DataSheet26.com

NSTS9117 PDF даташит

Спецификация NSTS9117 изготовлена ​​​​«JRC» и имеет функцию, называемую «SAW FILTER».

Детали детали

Номер произв NSTS9117
Описание SAW FILTER
Производители JRC
логотип JRC логотип 

4 Pages
scroll

No Preview Available !

NSTS9117 Даташит, Описание, Даташиты
NSTS9117 Jun. 2014
New JRC SAW FILTER
NSTS9117
Application
1589.5MHz GNSS 2nd Filter
Electrical Specification: (Table 1)
The device characteristics are measured in the circuit shown in Fig.1.
Item
Input and Output Impedance
Nominal Center Frequency (f0)
Insertion Loss
Response Variation
1589.5±16MHz
Input and Output VSWR
Group Delay Ripple(p-p)
Out of Band Rejection
100~1400MHz
(Relative to
1400~1525MHz
Through Level)
1489.5MHz
1645~1650MHz
1650~1840MHz
1689.5MHz
1840~2000MHz
2000~2500MHz
Spec.
-
-
3.5dB max.
1.7dB max.
2.3 max.
20ns max.
38dB min.
25dB min.
40dB min.
35dB min.
35dB min.
40dB min.
30dB min.
27dB min.
Typ.
50Ω
1589.5MHz
2.5dB
0.8dB
1.9
8ns
43dB
38dB
44dB
50dB
44dB
49dB
40dB
35dB
Maximum Rating: (Table 2)
Table 2. Maximum Ratings
Item
Maximum Input Power (In Band)
Maximum DC Voltage
Operating Temperature
Storage Temperature
Operating Temperature Limit : -40~+105ºC
Rating
+10dBm
7.5V
-40~+105ºC
-40~+110ºC
Mechanical Specifications: (Fig.2)
Package is designed as small as 2.0x1.6x0.65[mm3] for SMD (Surface Mount Device) type.
Notice:
This part is electrostatic discharge sensitive and may be damaged by improper handling.
http://www.njr.co.jp/products/device/index.html
http://www.njr.com/products/device/index.html









No Preview Available !

NSTS9117 Даташит, Описание, Даташиты
IN
50Ω
14
SA W
23
OUT
50Ω
NSTS9117 Jun. 2014
Fig.1 Measuring circuit
(2)
2.0±0.15
(1) (3)
261
YC
(4)
2
3
1 4-
4
0.55±0.10
Fig.2 Package dimensions (in mm)
2. 20
Marking
Lot Number
(1) Year
(2) Month
*Oct.---
Nov.---
Dec.---
(3) Date
*1-9---
10-19---
20-31---
(4) Part Number Mark
X
Y
Z
0
1
2
Pin no.
1
2
3
4
Connection
GND
IN
GND
OUT
4- 0. 65
Fig.3 Desirable land area (in mm)









No Preview Available !

NSTS9117 Даташит, Описание, Даташиты
NSTS9117 Jun. 2014
Notice
1. Use this component within operating temperature range. It might not be
satisfied with electrical specification without operating temperature range.
When it is used less than -40ºC or more than +105ºC, it might be a cause of
degradation or destruction of the component. Even if it endures during a short
time, it causes degradation of qualification.
2. When soldering iron is used, solder with the temperature at the tip of soldering
iron: 350ºC max., the time of soldering: 5 seconds max., the power of
soldering iron: 30W max..
3. Notice that the allowed time of soldering with soldering iron is accumulated
time, when soldering is repeated.
4. As rapid temperature change for cleaning after reflow soldering might be a
cause of destruction clean this component after confirming that temperature of
this component goes down to room temperature.
5. Confirm that there are not any influence for qualification to this component in
mounting on PCB when this component is cleaned.
6. As it might be a cause of degradation of destruction to apply static electricity to
this component, do not apply static electricity or excessive voltage while
assembling and measuring. And do not transport this component with bare
hand.
7. As it might be a cause of degradation or destruction to apply D.C. voltage
between each terminal, apply D.C. voltage 7.5V max. in actual circuit.
Note
1. This specification specifies the quality of this component as a single unit. Make
sure that this component is evaluated and confirmed against this specification
when it is mounted to your products.
2. The information contained herein may be changed without prior notice. It is
therefore advisable to contact New Japan Radio Company before proceeding
with the design of equipment incorporating this product.
3. The products are designed to be used with ordinary electronic equipment (data
and communications equipment, office equipment, audio-video equipment,
measuring instruments, etc). New Japan Radio Company does not assume any
liability for the case using the products with the application required high
reliability or safety extremely (such as space equipment, sea-bottom equipment,
medical equipment etc). When intending to use any our product please
contact our sales representatives in advance.










Скачать PDF:

[ NSTS9117.PDF Даташит ]

Номер в каталогеОписаниеПроизводители
NSTS9116SAW FILTERJRC
JRC
NSTS9117SAW FILTERJRC
JRC
NSTS9118SAW FILTERJRC
JRC
NSTS9119SAW FILTERJRC
JRC

Номер в каталоге Описание Производители
TL431

100 мА, регулируемый прецизионный шунтирующий регулятор

Unisonic Technologies
Unisonic Technologies
IRF840

8 А, 500 В, N-канальный МОП-транзистор

Vishay
Vishay
LM317

Линейный стабилизатор напряжения, 1,5 А

STMicroelectronics
STMicroelectronics

DataSheet26.com    |    2020    |

  Контакты    |    Поиск