|
|
PDF HMC1190ALP6NE Data sheet ( Hoja de datos )
| Número de pieza | HMC1190ALP6NE | |
| Descripción | BROADBAND HIGH IP3 DUAL CHANNEL DOWNCONVERTER | |
| Fabricantes | Analog Devices | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de HMC1190ALP6NE (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
|
No Preview Available !
HMC1190ALP6NE
v00.0615
BROADBAND HIGH IP3 DUAL CHANNEL DOWNCONVERTER
w/ Fractional-N PLL & VCO, 0.7 - 3.8 GHz
Typical Applications
Features
The HMC1190ALP6NE is Ideal for:
• Multiband/Multi-standard Cellular BTS Diversity
Receivers
• GSM & 3G & LTE/WiMAX/4G
• MIMO Infrastructure Receivers
• Wideband Radio Receivers
• Multiband Basestations & Repeaters
Functional Diagram
General Description
Broadband Operation with no external matching
High-side and Low-side LO injection Operation
High Input IP3 of +24 dBm
Power Conversion Gain of 8.9 dB
Input P1dB of 11 dBm
SSB Noise Figure of 9 dB
55 dBc Channel-to-Channel Isolation
Enable/Disable Mixer and PLLVCO independently
Single-ended RF input ports
Maximum Phase Detector Rate: 100 MHz
Low Phase Noise: -110 dBc/Hz in Band Typical
PLL FOM:
-230 dBc/Hz Integer Mode, -227 dBc/Hz Frac-
tional Mode
< 180 fs Integrated RMS Jitter (1 kHz to 20 MHz)
LO Low Noise Floor: -165 dBc/Hz
Mixer Low Noise Floor: -161 dBc/Hz
Integrated VCO
External VCO Input, differential LO output
Exact Frequency Mode:
0 Hz Fractional Frequency Error
Programmable RF Output Phase
Output Phase Synchronous Frequency Changes
Output Phase Synchronization
LO Output Mute Function
Compact Solution, 6x6 mm Leadless QFN Package
The HMC1190ALP6NE is a high linearity broadband dual channel downconverting mixer with integrated PLL and VCO
optimized for multi-standard receiver applications that require a compact, low power design. Integrated wideband
limiting LO amplifiers enable the HMC1190ALP6NE to achieve an unprecedented RF bandwidth of 700 MHz to 3500
MHz for applications including Cellular/3G, LTE/WiMAX/4G. Unlike conventional narrow-band downconverters, the
HMC1190ALP6NE supports both high-side and low-side LO injection over all RF frequencies. The RF and LO input
ports are internally matched to 50 Ohms.
The HMC1190ALP6NE features an integrated LO and RF baluns, enable control of IF and LO amplifiers and bias
control interface to high linearity passive mixer cores. Balanced passive mixer combined with high-linearity IF am-
plifier architecture provides excellent LO-to-RF, LO-to-IF, and RF-to-IF isolations. Low noise figure of 9 dB, and high
IIP3 of +24 dBm allow the HMC1190ALP6NE to be used in most demanding applications. External bias control pins
enable optimization of already low power dissipation of 2.34 W (typical). Fast enable control interface reduces power
consumption further in TDD applications.
External VCO input allows the HMC1190ALP6NE to lock external VCOs, and enables cascaded LO architectures for
MIMO applications. Two separate Charge Pump (CP) outputs enable separate loop filters optimized for both integrated
and external VCOs, and seamless switching between integrated or external VCOs during operation. Programmable
RF output phase features can further phase adjust and synchronize multiple HMC1190ALP6NE’s enabling scalable
MIMO and beam-forming radio architectures.
Additional features include configurable LO output mute function, Exact Frequency Mode that enables the
HMC1190ALP6NE to generate fractional frequencies with 0 Hz frequency error, and the ability to synchronously
change frequencies without changing phase of the output signal that increases efficiency of digital pre-distortion
loops. The HMC1190ALP6NE is housed in RoHS compliant compact 6x6 mm leadless QFN package.
For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824
1
Phone: 978-250-3343 Fax: 978-250-3373 Order On-line at www.hittite.com
Application Support: Phone: 978-250-3343 or [email protected]
1 page  
HMC1190ALP6NE
v00.0615
BROADBAND HIGH IP3 DUAL CHANNEL DOWNCONVERTER
w/ Fractional-N PLL & VCO, 0.7 - 3.8 GHz
Table 3. PLL & VCO Specifications
Logic Inputs
Parameter
Logic High
Logic Low
Input Current
Input Capacitance
LO Output Characteristics
LO Output Frequency
VCO Frequency at PLL Input
VCO Fundamental Frequency
VCO Output Divider
VCO Output Divider Range
PLL RF Divider Characteristics
19-Bit N Divider Range
Phase Detector (PD)
PD Frequency
Harmonics
fo Mode at 4000 MHz
VCO Output Divider
VCO RF Divider Range
PLL RF Divider Characteristics
19-Bit N-Divider Range (Integer)
19-Bit N-Divider Range (Fractional)
REF Input Characteristics
Max Ref Input Frequency
Ref Input Voltage
Ref Input Capacitance
14-\Bit R-Divider Range
VCO Open Loop Phase Noise at fo @ 4 GHz
10 kHz Offset
100 kHz Offset
1 MHz Offset
10 MHz Offset
100 MHz Offset
Conditions
Min.
1.2
50
2000
2000
1, 2, 4, ... 60, 62
1
Integer
Fractional
16
20
Fractional Mode
Integer Mode
DC
DC
2nd / 3rd / 4th
1,2,4,6,8,... 62
1
Max = 219 - 1
Fractional nominal divide ratio
varies (-3 / +4) dynamically max
16
20
AC Coupled
1
1
Typ.
Max.
Units
V
0.6 V
±1 uA
2 pF
4100
4100
4100
MHz
MHz
MHz
62
524287
524283
100 MHz
100 MHz
-30/-22/-32
dBc
62
524,287
524,283
2
-78
-108
-134.5
-156
-167
350
3.3
5
16,383
MHz
Vpp
pF
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824
Phone: 978-250-3343 Fax: 978-250-3373 Order On-line at www.hittite.com
Application Support: Phone: 978-250-3343 or [email protected]
4
5 Page 
HMC1190ALP6NE
v00.0615
BROADBAND HIGH IP3 DUAL CHANNEL DOWNCONVERTER
w/ Fractional-N PLL & VCO, 0.7 - 3.8 GHz
Figure 25. Low Side LO Conversion Gain
vs. Frequency @ VGATE=4.9V [1][2]
12
10
8
6
4
2
0
0,7
1,1 1,5
+25C
1,9 2,2 2,6
FREQUENCY (GHz)
+85C
3
3,4 3,8
-40C
Figure 26. Low Side LO Input IP3 vs.
Frequency @ VGATE=4.9V[2]
31
29
27
25
23
21
19
17
15
0,7 1,1 1,5 1,9 2,2 2,6
3
FREQUENCY (GHz)
3,4 3,8
+25C
+85C
-40C
Figure 27. High Side LO Conversion Gain
vs. Frequency @ VGATE=4.9V [1][2]
12
10
8
6
4
2
0
0,7
1,1 1,5
+25C
1,9 2,2 2,6
FREQUENCY (GHz)
+85C
3
3,4 3,8
-40C
Figure 28. High Side LO Input IP3 vs.
Frequency @ VGATE=4.9V[2]
31
29
27
25
23
21
19
17
15
0,7
1,1 1,5
+25C
1,9 2,2 2,6
FREQUENCY (GHz)
+85C
3
3,4 3,8
-40C
Figure 29. Low Side LO Noise Figure vs.
Temperature @ VGATE=4.9V
18
16
14
12
10
8
6
4
0.7 1.1 1.5 1.9 2.3 2.7 3.1 3.5
FREQUENCY (GHz)
Figure 30. High Side LO Noise Figure vs.
Temperature @ VGATE=4.9V
18
16
14
12
10
8
6
4
0.7 1.1 1.5 1.9 2.3 2.7 3.1 3.5
FREQUENCY (GHz)
[1] Balun losses at IF output ports are de-embedded.
[2] At room temperature
For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824
Phone: 978-250-3343 Fax: 978-250-3373 Order On-line at www.hittite.com
Application Support: Phone: 978-250-3343 or [email protected]
10
11 Page | ||
| Páginas | Total 30 Páginas | |
| PDF Descargar | [ Datasheet HMC1190ALP6NE.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| HMC1190ALP6NE | BROADBAND HIGH IP3 DUAL CHANNEL DOWNCONVERTER | Analog Devices |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |