PDF ADF7030-1 Data sheet ( Hoja de datos )

Número de pieza	ADF7030-1
Descripción	Radio Transceiver IC
Fabricantes	Analog Devices
Logotipo
Hay una vista previa y un enlace de descarga de ADF7030-1 (archivo pdf) en la parte inferior de esta página. Total 30 Páginas
No Preview Available ! Data Sheet FEATURES Radio frequency (RF) ranges 169.4 MHz to 169.6 MHz 426 MHz to 470 MHz 863 MHz to 960 MHz Data rates 2FSK/2GFSK: 0.1 kbps to 300 kbps 4FSK/4GFSK: 1 kbps to 360 kbps (transmit only) Dual power amplifiers (PAs) Programmable receiver channel bandwidth (BW) from 2.6 kHz to 738 kHz Receiver (Rx) performance Up to 102 dB blocking at ±20 MHz offset Up to 66 dB adjacent channel rejection −134.3 dBm sensitivity at 0.1 kbps −121.2 dBm sensitivity at 2.4 kbps Transmitter (Tx) performance −20 dBm to +17 dBm range with 0.1 dB step resolution Very low output power variation vs. temperature and supply Low active current 50 mA Tx current at 17 dBm 21.2 mA Rx current at12.5 kbps Ultralow sleep current 10 nA with memory retained Autonomous smart wake modes Host microprocessor interface Easy to use programming serial peripheral interface (SPI) Configurable 8-bit general-purpose input/output (GPIO) bus High Performance, Sub GHz Radio Transceiver IC ADF7030-1 On-chip ARM Cortex-M0 processor for Radio control and calibration Packet management Clear channel assessment (CCA) IEEE802.15.4g support Frame format Data whitening Dual-sync word detection Forward error correction (FEC) and interleaving Suitable for systems targeting compliance with ETSI EN 300 220-1 EN 54-25, EN 13757-4 FCC Part 15, Part 22, Part 24, Part 90, and Part 101 ARIB STD-T30, STD-T67, STD-T108, STD-T96 Packages 6 mm × 6 mm, 40-lead LFCSP 7 mm × 7 mm, 48-lead LQFP APPLICATIONS IEEE 802.15.4g (MR-FSK PHY) Wireless M-Bus (EN 13757-4) Smart metering Security and building automation Active tag asset tracking Industrial control Wireless sensor networks (WSNs) CREGx FUNCTIONAL BLOCK DIAGRAM HFXTALN HFXTALP GPIO6 GPIO7 LDOx TCXO 26MHz BUFFER OSC 32kHz 26kHz OSC RC OSC LNAIN1 LNAIN2 PAOUT1 LNA RECEIVER PA SYNTHESIZER DIGITAL BASEBAND PAOUT2 PA TRANSMITTER ARM® CORTEX®-M0 ROM RAM ADF7030-1 INTERRUPT CONTROLLER SPI SLAVE CONFIGURABLE GPIOs TEMPERATURE SENSOR SPI GPIOx NOTES 1. CREGx, GPIOx, AND SPI CONTAIN MULTIPLE PINS. Figure 1. Rev. 0 Document Feedback Information furnished by Analog Devices is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other rights of third parties that may result from its use. Specifications subject to change without notice. No license is granted by implication or otherwise under any patent or patent rights of Analog Devices. Trademarksandregisteredtrademarksarethepropertyoftheirrespectiveowners. One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A. Tel: 781.329.4700 ©2016 Analog Devices, Inc. All rights reserved. Technical Support www.analog.com 1 page ADF7030-1 Data Sheet SPECIFICATIONS VDD = VBAT1 = VBAT2 = VBAT3 = VBAT4 = VBAT5 = VBAT6 = 2.2 V to 3.6 V, exposed pad (EPAD) = 0 V (ground), TA = TMIN to TMAX, unless otherwise noted. Typical specifications are at VDD = 3 V, TA = 25°C, unless otherwise noted. All VBATx pins must be tied together. A one-time radio calibration is required, unless otherwise noted. TEMPERATURE AND VOLTAGE Table 1. Parameter TEMPERATURE RANGE, TA VOLTAGE SUPPLY VBATx Pin Voltage Min −40 2.2 2.85 PA LDO voltage + 0.2 V Typ Max +85 3.6 3.6 3.6 Unit Test Conditions/Comments °C V Transmit power ≤ 13 dBm V Transmit power ≥ 17 dBm, PA LDO voltage = 2.65 V V Transmit power >13 dBm and < 17 dBm; the PA LDO voltage is configurable GENERAL RF Table 2. Parameter RF FREQUENCY Frequency Range Channel Frequency Resolution DATA RATE IEEE802.15.4g Packet Mode 2FSK, 2GFSK Modulation Generic Packet Mode 2FSK, 2GFSK Modulation 4FSK, 4GFSK Modulation On/Off Keying (OOK) Modulation Resolution FREQUENCY DEVIATION Range 2FSK, 2GFSK Modulation 4FSK, 4GFSK Modulation Resolution GAUSSIAN FILTER BANDWIDTH TIME (BT) PRODUCT Min Typ 169.4 426 863 1.5 Max 169.6 470 960 2.4 0.1 1 16.384 1 150 300 360 1 250 1 250 100 0.3, 0.35, 0.4, 0.5 Unit Test Conditions/Comments MHz MHz MHz Hz kbps kbps kbps kbps kbps bps Tx only, generic packet mode only Tx only, Manchester encoded, generic packet mode only kHz kHz Tx only, generic packet mode only Hz Programmable Rev. 0 \| Page 4 of 55 5 Page ADF7030-1 Data Sheet Parameter Alternate Channel (±25 kHz) ±2 MHz ±10 MHz CHANNEL SELECTIVITY AND BLOCKING— ETSI EN 300 220-1 TEST METHOD Configuration 169.43125 MHz/2.4 kbps Min Typ 69 91 95 ±2 MHz ±10 MHz Configuration 169.41875 MHz/4.8 kbps −15 −12 ±2 MHz ±10 MHz COCHANNEL REJECTION −16 −13 Configuration 169.43125 MHz/2.4 kbps Configuration 169.41875 MHz/4.8 kbps CALIBRATED IMAGE REJECTION −10 −10 Configuration 169.43125 MHz/2.4 kbps ADJACENT CHANNEL POWER (ACP) Configuration 169.43125 MHz/2.4 kbps Adjacent Channel Alternate Channel Configuration 169.41875 MHz/4.8 kbps Adjacent Channel Alternate Channel Configuration 169.46875 MHz/6.4 kbps Adjacent Channel Alternate Channel OCCUPIED BANDWIDTH (OBW) 55 −83 −82 −59 −81 −68 −81 Configuration 169.43125 MHz/2.4 kbps Configuration 169.41875 MHz/4.8 kbps Configuration 169.46875 MHz/6.4 kbps SPURIOUS EMISSIONS (EXCLUDING HARMONICS) Receive <1 GHz 1 GHz to 4 GHz 6.3 7.8 8.2 −58 −49 Max Unit Test Conditions/Comments dB dB dB Measured as per EN 300 220-1 V2.4.1, AFC disabled Desired signal level = −106.7 dBm (3 dB above the reference sensitivity level) dBm dBm Desired signal level = −105.8 dBm (3 dB above the reference sensitivity level) dBm dBm Desired signal 3 dB above the input sensitivity level (PER = 5%), CW interferer power level increased until PER = 5%, AFC enabled dB dB dB Desired signal 3 dB above the input sensitivity level (PER = 5%), CW interferer power level increased until PER = 5%, AFC enabled, image calibrated dB Spectrum analyzer settings: resolution bandwidth (RBW) = 100 Hz, video bandwidth (VBW) = 300 Hz PA1, output power = 13 dBm dBc dBc PA2, output power = 17 dBm dBc dBc PA1, output power = 13 dBm dBc dBc Occupied bandwidth is the bandwidth containing 99% of the total integrated power; spectrum analyzer settings: RBW = 100 Hz, VBW = 300 Hz kHz PA1, output power = 13 dBm kHz PA2, output power = 17 dBm kHz PA1, output power = 13 dBm Measured conductively at antenna input; RF frequency = 169.43125 MHz dBm dBm Transmit <1 GHz 1 GHz to 4 GHz HARMONIC EMISSIONS 17 dBm Output Power Second Harmonic Third Harmonic All Other Harmonics −75 −78 −81 −90 <−90 PA2, output power = 17 dBm, transmitting continuous carrier wave dBc dBc Measured conductively at antenna input, transmitting continuous carrier wave; RF frequency = 169.43125 MHz PA2 dBc dBc dBc Rev. 0 \| Page 10 of 55 11 Page

Páginas	Total 30 Páginas
PDF Descargar	[ Datasheet ADF7030-1.PDF ]

Hoja de datos destacado

Número de pieza	Descripción	Fabricantes
ADF7030-1	Radio Transceiver IC	Analog Devices

Número de pieza	Descripción	Fabricantes
SLA6805M	High Voltage 3 phase Motor Driver IC.	Sanken
SDC1742	12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.	Analog Devices

DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.

DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar