NTE1690 PDF даташит
Спецификация NTE1690 изготовлена «NTE» и имеет функцию, называемую «Integrated Circuit Telephone DTMF Dialer». |
|
Детали детали
Номер произв | NTE1690 |
Описание | Integrated Circuit Telephone DTMF Dialer |
Производители | NTE |
логотип |
4 Pages
No Preview Available ! |
NTE1690
Integrated Circuit
Telephone DTMF Dialer
Description:
The NTE1690 is a low threshold voltage, field–implanted, metal gate CMOS integrated circuit in a
16–Lead DIP type package. This device interfaces directly to a standard telephone keypad and gen-
erates all dual tone multi–frequency pairs required in tone dialing systems. The tone synthesizers
are locked to an on–chip reference oscillator using an inexpensive 3.579545MHz crystal for high tone
accuracy. The crystal and an output load resistor are the only external components required for tone
generation. A MUTE OUT logic signal, which changes state when any key is depressed is also pro-
vided.
Features:
D 3V to 10V Operation When Generating Tones
D 2V Operation of Keyscan and MUTE Logic
D Static Sensing of Key Closures or Logic Inputs
D On–Chip 3.579545MHz Crystal–Controlled Oscillator
D Output Amplitudes Proportional to Supply Voltage
D High Group Pre–Emphasis
D Low Harmonic Distortion
D Open Emitter–Follower Low–Impedance Output
D SINGLE TONE INHIBIT Pin
Absolute Maximum Ratings:
Supply Voltage (VDD – VSS) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15V
Maximum Voltage at Any Pin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . VDD+0.3V to VSS–0.3V
Power Dissipation, PD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 500mW
Operating Temperature Range, Topr . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –30° to +60°C
Storage Temperature Range, Tstg . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –55° to +150°C
Electrical Characteristics: (–30°C < TA < +60°C, 3V < VDD < 10V unless otherwise specified)
Parameter
Test Conditions Min Typ Max Unit
Minimum Supply Voltage for Keysense and
MUTE Logic Functions
––2
V
Operating Current, Idle
Operating Current, Generating Tones
RL = 10kΩ
VO = 5V
– 20 –
µA
– 2 – mA
No Preview Available ! |
Electrical Characteristics (Cont’d): (–30°C < TA < +60°C, 3V < VDD < 10V unless othewise specified)
Parameter
Test Conditions Min Typ Max Unit
Input Resistors
COLUMN and ROW (Pull–Up)
– 40 –
kΩ
SINGLE TONE INHIBIT (Pull–Down)
– 50 –
kΩ
TONE DISABLE (Pull–Up)
– 50 –
kΩ
MUTE OUT Sink Current (COLUMN and ROW Active)
Output Amplitudes, Low Group
Output Amplitudes, High Group
Mean Output DC Offset
High Group Pre–Emphasis
VDD = 3V, VO = 0.5V 0.5 –
– mA
RL = 240Ω, VDD = 3V – 250 – mVrms
RL = 240Ω, VDD = 10V – 850 – mVrms
RL = 240Ω, VDD = 3V – 315 – mVrms
RL = 240Ω, VDD = 10V – 1000 – mVrms
VDD = 3V
– 1.2 –
V
VDD = 10V
– 4.2 –
V
2.4 2.7 3.0 dB
Dual Tone/Harmonic Distortion Ratio
1MHz Bandwidth
22 – – dB
Start–Up Time (90% Amplitude)
– 3 5 ms
Note 1. Crystal Specification: Parallel Resonant 3.579545MHz, RS ≤ 150Ω, L = 100mH, C0 = 5pF,
C1 = 0.02pf.
Pin Descriptions:
VDD (Pin1): This is the positive voltage supply to the device, referenced to VSS. The collector of the
TONE OUT transistor is connected to this pin.
VSS (Pin6): This is the negative voltage supply.
OSCILLATOR (Pin7 and Pin8): All tone generation timing is derived from the on–chip oscillator cir-
cuit. A low–cost 3.579545MHz A–cut crystal (NTSC TV color–burst) is needed between Pin7 and
Pin8. Load capacitors and feedback resistor are included on–chip for good start–up and stability.
The oscillator stops when column inputs are sensed with no valid input having been detected. The
oscillator is also stopped when the TONE DISABLE input is pulled to logic low.
Row and Column Inputs (Pins 3, 4, 5, 9, 11, 12, 13, 14): When no key is pushed, pull–up resistors
are active on row and column inputs. A key closure is recognized when a single row and a single
column are connected to VSS, which starts the oscillator and initiates tone generation. Negative–true
logic signals simulating key closures can also be used.
TONE DISABLE Input (Pin2): The TONE DISABLE input has an internal pull–up resistor. When this
input is open or at logic high, the normal tone output mode will occur. When TONE DISABLE input
is at logic low, the device will be in the inactive mode, TONE OUTPUT will be at an open circuit state.
MUTE Output (Pin10): The MUTE output is an open–drain N–channel device that sinks current to
VSS with any key input and is open when no key input is sensed. The MUTE output will switch regard-
less o the state of he SINGLE TONE INHIBIT input.
SINGLE TONE INHIBIT Input (Pin15): The SINGLE TONE INHIBIT input is used to inhibit the gener-
ation of other than valid tone pairs due to multiple row–column closures. It has a pull–down resistor
to VSS, and when left open or tied to VSS any input condition that would normally result in a single tone
will now result in no tone, with all other functions operating normally. When tied to VDD, single or dual
tones may be generated (See Table II).
TONE OUT (Pin16): This output is the open emitter of an NPN transistor, the collector of which is
connected to VDD. When an external load resistor is connected from TONE OUT to VSS, the output
voltage on this pin is the sum of the high and low group sine–waves superimposed on a DC offset.
When not generating tones, this output transistor is turned OFF to minimize the device idle current.
No Preview Available ! |
Pin Descriptions (Cont’d):
Adjustment of the emitter load resistor results in variation of the mean DC current during tone genera-
tion, the sine–wave signal current through the output transistor, and the output distortion. Increasing
values of load resistances decreases both the signal current and distortion.
Functional Description:
With no key inputs to the device the oscillator is inhibited, the output transistor is pulled OFF and de-
vice current consumption is reduced to a minimum. Key closures are sensed statically to ensure no
modification of the line when tones are not being generated. Any key closure activates the MUTE
output, starts the oscillator and sets the high group and low group programmable counters to the ap-
propriate divide ratio. These counters sequence two ratioed–capacitor D/A converters through a se-
ries of 28 equal duration steps per sine–wave cycle. The two tones are summed by a mixer amplifier,
with pre–emphasis applied to the high group tone. The output is an NPN emitter–follower requiring
the addition of an external load resistor to VSS. This resistor facilitates adjustment of the signal current
flowing from VDD through the output transistors.
The amplitude of the output tones is directly proportional to the device supply voltage.
Tone
Group
Low
Group
fL
High
Group
fH
Table I. Output Frequency Accuracy
Valid
Input
Standard
DTMF (Hz)
Tone Output % Deviation
Frequency from Standard
R1 697
694.8
–0.32
R2 770
770.1
+0.02
R3 852
852.4
+0.03
R4 941
940.0
–0.11
C1 1209
1206.0
–0.24
C2 1336
1331.7
–0.32
C3 1477
1486.5
+0.64
C4 16334
1639.0
+0.37
SINGLE TONE
INHIBIT
X
X
X
1
1
1
0
0
0
Table II. Functional Truth Table
TONE
DISABLE
ROW
COLUMN
Tones
Low
High
O X X 0V 0V
X O/C O/C 0V 0V
1
One
One
fL fH
1
2 or More
One
– fH
1
One
2 or More
fL
–
1
2 or More
2 or More
VOS
VOS
1
2 or More
One
VOS
VOS
1
One
2 or More
VOS
VOS
1
2 or More
2 or More
VOS
VOS
Note 2. X is don’t care state.
Note 3. VOS is the output offset voltage.
MUTE
0
0
1
1
1
1
1
1
1
Скачать PDF:
[ NTE1690.PDF Даташит ]
Номер в каталоге | Описание | Производители |
NTE169 | (NTE166 - NTE170) Single Phase Bridge Rectifier 2.0 Amp | NTE |
NTE169 | Diode ( Rectifier ) | American Microsemiconductor |
NTE1690 | Integrated Circuit Telephone DTMF Dialer | NTE |
NTE1691 | Integrated Circuit Telephone Pulse Dialer w/Redial | NTE |
Номер в каталоге | Описание | Производители |
TL431 | 100 мА, регулируемый прецизионный шунтирующий регулятор |
Unisonic Technologies |
IRF840 | 8 А, 500 В, N-канальный МОП-транзистор |
Vishay |
LM317 | Линейный стабилизатор напряжения, 1,5 А |
STMicroelectronics |
DataSheet26.com | 2020 | Контакты | Поиск |