|
|
PDF ZL60102 Data sheet ( Hoja de datos )
| Número de pieza | ZL60102 | |
| Descripción | (ZL60101 / ZL60102) 12 x 2.7 Gbps Parallel Fiber Optic Link Transmitter and Receiver | |
| Fabricantes | Zarlink Semiconductor | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de ZL60102 (archivo pdf) en la parte inferior de esta página. Total 20 Páginas | ||
|
No Preview Available !
ZL60101/2
12 x 2.7 Gbps Parallel Fiber Optic Link
Transmitter and Receiver
Data Sheet
Features
• 12 parallel channels, total 32.6 Gbps capacity
• Data rate up to 2.72 Gbps per channel
• 850 nm VCSEL array
• Data I/O is CML compatible with DC blocking
capacitors
• Link reach 300 m with 50/125 µm 500 MHz.km
fiber at 2.5 Gbps
• Channel BER better than 10-12
• Industry standard MPO/MTP ribbon fiber
connector interface
• Pluggable MegArray® ball grid array connector
• Optionally available with EMI shield and external
heat sink
• Laser class 1M IEC 60825-1:2001 compliant
• Power supply 3.3 V
• Compatible with industry MSA
Applications
• High-speed interconnects within and between
switches, routers and transport equipment
• Proprietary backplanes
• Low cost SONET/SDH VSR (Very Short Reach)
OC-192/STM64 connections
• InfiniBand® connections
• Interconnects rack-to-rack, shelf-to-shelf, board-
to-board, board-to-optical backplane
June 2004
Ordering Information
ZL60101/MJD Parallel Fiber Transmitter
ZL60102/MJD Parallel Fiber Receiver
Heat sink and EMI shield options
are available upon request
0°C to +80°C
Description
The ZL60101 and ZL60102 together make a very high
speed transmitter/receiver pair for parallel fiber
applications.
The ZL60101 transmitter module converts parallel
electrical input signals via a laser driver and a VCSEL
array into parallel optical output signals at a wavelength
of 850 nm.
The ZL60102 receiver module converts parallel optical
input signals via a PIN photodiode array and a
transimpedance and limiting amplifier into electrical
output signals.
The modules are pluggable each fitted with an industry-
standard MegArray® BGA connector. This provides
ease of assembly on the host board and enables
provisioning of bandwidth on demand.
1
Zarlink Semiconductor Inc.
Zarlink, ZL and the Zarlink Semiconductor logo are trademarks of Zarlink Semiconductor Inc.
Copyright 2003-4, Zarlink Semiconductor Inc. All Rights Reserved.
1 page  
ZL60101/2
Data Sheet
Classified in accordance with IEC 60825-1/A2:2001, IEC 60825-2 : 2000
Class 1M Laser Product
Emited wavelength: 840 nm
DIN0+
DIN0-
DIN11+
DIN11-
VCSEL
Driver
VCSEL
Array
VCSEL Driver Controller
0
1
2
3
4
5
6
7
8
9
10
11
VCC VEE RESET Tx_DIS Tx_EN FAULT
Figure 2 - ZL60101 Transmitter Block Diagram
Ch 11 Ch 10
Ch 9
Front view - MTP key up
Ch 8 Ch 7 Ch 6 Ch 5 Ch 4 Ch 3
Host circuit board
Table 1 - Transmitter Optical Channel Assignment
Ch 2
Ch 1
Ch 0
5
Zarlink Semiconductor Inc.
5 Page 
ZL60101/2
Data Sheet
0
1
2
3
4
5
PIN
6
7
Array
8
9
10
11
Trans-
Impedance
and
Limiting
Amplifier
DOUT0+
DOUT0-
DOUT11+
DOUT11-
VCC VEE
Rx_EN Rx_SD SQ_EN
Figure 8 - ZL60102 Receiver Block Diagram
Ch 11 Ch 10 Ch 9
Front view - MTP key up
Ch 8 Ch 7 Ch 6 Ch 5 Ch 4 Ch 3
Host circuit board
Table 4 - Receiver Optical Channel Assignment
Ch 2
Ch 1
Ch 0
Receiver Control and Status Signals
The following table shows the timing relationships of the status and control signals of the pluggable optical receiver.
Parameter
Control input voltage high1
Control input voltage low1
Control input pull-up current1
Status output voltage low2, 3
Status output pull-up resistor2
Receiver signal detect assert time
Receiver signal detect de-assert time
Receiver enable assert time
Receiver enable de-assert time
1. Applies to control signals Rx_EN, SQ_EN.
2. Applies to status signal Rx_SD. Internal pull-up to VCC.
3. With status output sink current max 2 mA.
Symbol
VIH
VIL
IIN
VOL
RPU
TSD
TLOS
TRXEN
TRXD
Min.
2.0
10
Typ.
3.25
50
50
33
5
Max.
0.9
100
0.4
200
200
Unit
V
V
µA
V
kΩ
µs
µs
ms
µs
11
Zarlink Semiconductor Inc.
11 Page | ||
| Páginas | Total 20 Páginas | |
| PDF Descargar | [ Datasheet ZL60102.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| ZL60101 | (ZL60101 / ZL60102) 12 x 2.7 Gbps Parallel Fiber Optic Link Transmitter and Receiver | Zarlink Semiconductor |
| ZL60102 | (ZL60101 / ZL60102) 12 x 2.7 Gbps Parallel Fiber Optic Link Transmitter and Receiver | Zarlink Semiconductor |
| ZL60105 | (ZL60105 / ZL60106) Parallel Fiber Optic Link Transmitter and Receiver | Zarlink Semiconductor |
| ZL60106 | (ZL60105 / ZL60106) Parallel Fiber Optic Link Transmitter and Receiver | Zarlink Semiconductor |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |