DataSheet26.com

SCDQ5543x PDF даташит

Спецификация SCDQ5543x изготовлена ​​​​«Osram Opto Semiconductors» и имеет функцию, называемую «(SCDQ5541x - SCDQ5544x) Intelligent Display / 0.134 Inch / 4-Character / 5 X 5 Dot Matrix».

Детали детали

Номер произв SCDQ5543x
Описание (SCDQ5541x - SCDQ5544x) Intelligent Display / 0.134 Inch / 4-Character / 5 X 5 Dot Matrix
Производители Osram Opto Semiconductors
логотип Osram Opto Semiconductors логотип 

13 Pages
scroll

No Preview Available !

SCDQ5543x Даташит, Описание, Даташиты
YELLOW SCDQ5541P/Q/R
HIGH EFFICIENCY RED SCDQ5542P/Q/R
GREEN SCDQ5543P/Q/R
HIGH EFFICIENCY GREEN SCDQ5544P/Q/R
Square 0.134" 4-Character
5x5 Dot Matrix Serial Input Dot Addressable
Intelligent Display® Devices
Typical Package Outline & Matrix
0.112 (2.83)
0.400 (10.16)
0.187 (4.75)
0.134 (3.40)
0.200 (5.08)
SCDQ554XP SIP Package
11
0.784 (19.91)
0.134 (3.40)
0.200 (5.08)
0.065 (1.65)
±.015 (±.38)
Pin 1
0.235 (5.96)
±.010 (±.25)
.012 x .018 (.30 x .46)
±.002 (±.05) Pin
0.079 (2.00) ±.010 (±.25)
Tolerance-Non Cum.
SCDQ554XQ 90° SIP Package
SCDQ554XR 90° Connector/Header Package
1 0.475 (12.07) Max.
11
±.445 (±11.30) Typ.
w 0.160 (4.06)
2
3
ww Pin 1
. 0.050 (1.27)
D 0.235 (5.96)
at ±.015 (±.38)
.012 x .018 (.30 x .46)
±.002 (±.05) Pin
0.079 (2.00)
±.010 (±.25)
0.365 (9.27) Max.
0.345 (8.76) Typ.
Pin 1
aS1.Par t marking is on this side of the display.
2.Mole x header, 53290-0510 mounted on the display.
h3.Mole x receptacle, 52418-0510 mounted on the customer's PCB. Supplied by the customer.
eUse Pin 1 designation on this drawing, not the Molex connector specification.
e4.Unless otherwise specified all tolerances are ±.010 (±.25)
t4U.c2000 Infineon Technologies Corp. • Optoelectronics Division • San Jose, CA
omwww.infineon.com/opto • 1-888-Infineon (1-888-463-4636)
1
0.393 (9.98)
±.015 (±.40)
0.157 (4.00)









No Preview Available !

SCDQ5543x Даташит, Описание, Даташиты
FEATURES
• Four 0.134" (3.40 mm) 5x5 Dot Matrix Characters in Yel-
low, High Efficiency Red, Green, or High Efficiency Green
• Optimum Display Surface Efficiency
(display area to package ratio)
• Square Character Format to Display Data in a
Vertical or Horizontal Format
• High Speed Data Input Rate: 5.0 MHz
• ROMless Serial Input, Dot Addressable Display—
Ideal for User Defined Characters
• Built-in Decoders, Multiplexers and LED Drivers
• Readable from 6 Feet (1.8 meters)
• Wide Viewing Angle, ±55°in X-Axis and Y-Axis
• Attributes:
– 100 Bit RAM for User Defined Characters
– Eight Dimming Levels
– Power Down Model (<250 µW)
– Software Clear Function
– Lamp Test
– 3.3 V Capability
DESCRIPTION
The SCDQ5541X (Yellow), SCDQ5542X (High Efficiency Red),
SCDQ5543X (Green), and SCDQ5544X (High Efficiency Green)
are four digit, dot addressable 5x5 dot matrix, serial input,
alphanumeric Intelligent Display devices in a square format.
The four digits are packaged in a rugged, high quality, optically
transparent, plastic package several mounting options. The SIP
Pin for standard display mounting and 90° Bend SIP for side
mounting. Additionally, a connector/header configuration is also
available for display side mounting.
The on-board CMOS has a 100 bit RAM, one bit associated
with one LED, each to generate User Defined Characters. In
Power Down Mode, quiescent current is <50 µA.
The SCDQ554XX is designed for work with the serial port of
most common microprocessors. Data is transferred into the
display through the Serial Data Input (DATA), clocked by the
Serial Data Clock (SDCLK), and enabled by the Load Input
(LOAD).
Absolute Maximum Ratings
Operation in excess of any of these conditions may result in
permanent damage to this device (TA=25°C).
Supply Voltage VCC to Gnd (non-operating) ............ –0.5 to 7.0 V
Input Voltage, Any Pin to Gnd......................–0.5 to VCC to 5.5 V
Operating Temperature Range .............................–40°C to 85°C
Storage Temperature (TS) ...................................–40°C to 100°C
Relative Humidity (non-condensing) .................................... 85%
Maximum Solder Temperature, Connector Only
0.063” below Seating Plane T5 s................................ 260°C
Maximum Power Dissipation .............................0.65 W at 85°C
ESD (100 pF, 1.5 k) ........................................................ 2.0 kV
Maximum Input Current .............................................. ±100 mA
Electrical characteristics (over operating temperature, un-
less otherwise specified, TA=25°C)
Parameter
Min.
Typ.
Max.
VCC
ICC (Pwr. Dwn. Mode)
ICC (16 dots on per digit)(1)
4.5 —
5.5
— — 5.0
— 100 145
VIH
VIL
IIH
IIL
Internal Mux Frequency
3.5 —
——
——
——
375 768
θja — 65
Notes:
1) ICC is an average value, the Peak current is 5/3 x ICC.
2) Contact manufacturer for 3.3 volt operation.
1.5
10
–10
1086
Input Circuit
The input resistor/diode network shown below is used for ESD
protection and to eliminate substrate latch-up caused by input
voltage over/under shoot.
Figure 1. Inputs
VCC
input
1.0 k
GND
Units
V
µA
mA
V
V
µA
µA
Hz
°C/W
Conditions
VCC=5.0 V, all inputs=0 V or VCC
VCC=5.0 V, “#” displayed in all 4 digits
at 100% brightness at 25°C
VCC=4.5 V to 5.5 V
VCC=4.5 V to 5.5 V
VCC=VIN=5.0 V (all inputs)
VCC=5.0 V, VIN=0 V (all inputs)
2000 Infineon Technologies Corp. • Optoelectronics Division • San Jose, CA
www.infineon.com/opto • 1-888-Infineon (1-888-463-4636)
SCDQ5541/5542/5543/5544/P/Q/R









No Preview Available !

SCDQ5543x Даташит, Описание, Даташиты
Figure 2. Close Up of Data “Write” Cycle
TLDS
LOAD
DATA
SDCLK
TDS
D0
TDH
TSDCW
TSDCLK
D7
Figure 3. Device Timing
TWR
LOAD
SDCLK
DATA
LOAD
D0 D1 D2 D3 D4 D5 D6 D7
OR
SDCLK
DATA
D0 D1 D2 D3 D4 D5 D6 D7
Write Cycle Timing
(over operating temperature range, VCC=VLL=4.5 V to 5.5 V)
Symbol
Description
Min.
TLDS
TDS
TSDCLK
TSDCW
(HI or LOW)
Load Setup Time
Data Setup Time
Clock Period
Clock Width
50
50
200
70
TLDH
TDH
TWR
TBL
TRST
Load Hold Time
Data Hold Time
Total Write Time
Time Between Writes
Reset Active Time
0
25
2.25
600
600
Notes:
1. TWR=Setup Time + 8 Clock Times + Hold Times + Time Between Writes.
2. Data is shifted into the display’s 8 bit shift register on the positive going edge of
the SDClk.
3. Shift register data is evaluated when Load\ goes high.
2000 Inneon Technologies Corp. Optoelectronics Division San Jose, CA
www.inneon.com/opto 1-888-Inneon (1-888-463-4636)
TLDH
TBL
D0
D0
Max.
Units
ns
ns
ns
ns
ns
ns
µs
ns
ns
SCDQ5541/5542/5543/5544/P/Q/R










Скачать PDF:

[ SCDQ5543x.PDF Даташит ]

Номер в каталогеОписаниеПроизводители
SCDQ5543(SCDQ5541x - SCDQ5544x) Intelligent Display / 0.134 Inch / 4-Character / 5 X 5 Dot MatrixOsram Opto Semiconductors
Osram Opto Semiconductors
SCDQ5543x(SCDQ5541x - SCDQ5544x) Intelligent Display / 0.134 Inch / 4-Character / 5 X 5 Dot MatrixOsram Opto Semiconductors
Osram Opto Semiconductors

Номер в каталоге Описание Производители
TL431

100 мА, регулируемый прецизионный шунтирующий регулятор

Unisonic Technologies
Unisonic Technologies
IRF840

8 А, 500 В, N-канальный МОП-транзистор

Vishay
Vishay
LM317

Линейный стабилизатор напряжения, 1,5 А

STMicroelectronics
STMicroelectronics

DataSheet26.com    |    2020    |

  Контакты    |    Поиск