DataSheet26.com

HA-2539 PDF даташит

Спецификация HA-2539 изготовлена ​​​​«Intersil Corporation» и имеет функцию, называемую «600MHz/ Very High Slew Rate Operational Amplifier».

Детали детали

Номер произв HA-2539
Описание 600MHz/ Very High Slew Rate Operational Amplifier
Производители Intersil Corporation
логотип Intersil Corporation логотип 

8 Pages
scroll

No Preview Available !

HA-2539 Даташит, Описание, Даташиты
Data Sheet
HA-2539
September 1998 File Number 2896.3
600MHz, Very High Slew Rate
Operational Amplifier
The Intersil HA-2539 represents the ultimate in high slew
rate, wideband, monolithic operational amplifiers. It has been
designed and constructed with the Intersil High Frequency
Bipolar Dielectric Isolation process and features dynamic
parameters never before available from a truly differential
device.
With a 600V/µs slew rate and a 600MHz gain bandwidth
product, the HA-2539 is ideally suited for use in video and
RF amplifier designs, in closed loop gains of 10 or greater.
Full ±10V swing coupled with outstanding AC parameters
and complemented by high open loop gain makes the
devices useful in high speed data acquisition systems.
For further design assistance please refer to Application Note
AN541 (Using the HA-2539 Very High Slew Rate Wideband
Operational Amplifiers) and Application Note AN556 (Thermal
Safe-Operating-Areas For High Current Operational Amplifiers.
For military grade product information, the HA-2539/883 data
sheet is available upon request.
Ordering Information
TEMP.
PART NUMBER RANGE (oC) PACKAGE
PKG. NO.
HA1-2539-2
-55 to 125 14 Ld CERDIP F14.3
HA1-2539-5
0 to 75 14 Ld CERDIP F14.3
HA3-2539-5
0 to 75 14 Ld PDIP
E14.3
Features
• Very High Slew Rate . . . . . . . . . . . . . . . . . . . . . . 600V/µs
• Open Loop Gain . . . . . . . . . . . . . . . . . . . . . . . . . . 15kV/V
• Wide Gain-Bandwidth (AV 10) . . . . . . . . . . . . . . 600MHz
• Power Bandwidth . . . . . . . . . . . . . . . . . . . . . . . . . 9.5MHz
• Low Offset Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . 8mV
• Input Voltage Noise . . . . . . . . . . . . . . . . . . . . . . 6nV/Hz
• Output Voltage Swing . . . . . . . . . . . . . . . . . . . . . . . . ±10V
• Monolithic Bipolar Dielectric Construction
Applications
• Pulse and Video Amplifiers
• Wideband Amplifiers
• High Speed Sample-Hold Circuits
• RF Oscillators
Pinout
HA-2539
(PDIP, CERDIP)
TOP VIEW
+IN 1
NC 2
V- 3
NC 4
NC 5
NC 6
NC 7
+
14 -IN
13 NC
12 NC
11 NC
10 +V
9 NC
8 OUTPUT
NOTE: No-Connection (NC) leads may be tied to a ground plane
for better isolation and heat dissipation.
1 CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Copyright © Intersil Corporation 1999









No Preview Available !

HA-2539 Даташит, Описание, Даташиты
HA-2539
Absolute Maximum Ratings
Supply Voltage Between V+ and V- Terminals. . . . . . . . . . . . . . 35V
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6V
Peak Output Current . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50mA
Continuous Output Current . . . . . . . . . . . . . . . . . . . . . . . 33mARMS
Operating Conditions
Temperature Range
HA-2539-2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -55oC to 125oC
HA-2539-5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0oC to 75oC
Thermal Information
Thermal Resistance (Typical, Note 2)
θJA (oC/W) θJC (oC/W)
CERDIP Package. . . . . . . . . . . . . . . . .
75
20
PDIP Package . . . . . . . . . . . . . . . . . . . 107
N/A
Maximum Internal Quiescent Power Dissipation (Note 1)
Maximum Junction Temperature (Ceramic Package) . . . . . . .175oC
Maximum Junction Temperature (Plastic Package) . . . . . . . . .150oC
Maximum Storage Temperature Range . . . . . . . . . . -65oC to 150oC
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . 300oC
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. Maximum power dissipation with load conditions must be designed to maintain the maximum junction temperature below 175oC for the ceramic
package and below 150oC for the plastic package. By using Application Note AN556 on Safe Operating Area equations, along with the thermal
resistances, proper load conditions can be determined. Heat sinking is recommended above 75oC.
2. θJA is measured with the component mounted on an evaluation PC board in free air.
Electrical Specifications VSUPPLY = ±15V, RL = 1k, CL < 10pF, Unless Otherwise Specified
PARAMETER
INPUT CHARACTERISTICS
Offset Voltage
Average Offset Voltage Drift
Bias Current
Offset Current
Input Resistance
Input Capacitance
Common Mode Range
Input Current Noise
(f = 1kHz, RSOURCE = 0)
Input Voltage Noise
(f = 1kHz, RSOURCE = 0)
TRANSFER CHARACTERISTICS
Large Signal Voltage Gain
(Note 3)
Common Mode Rejection Ratio
(Note 4)
Minimum Stable Gain
Gain Bandwidth (Notes 5, 6)
OUTPUT CHARACTERISTICS
Output Voltage Swing
(Notes 3, 10)
Output Current (Note 3)
Output Resistance
Full Power Bandwidth
(Notes 3, 7)
TEMP.
(oC)
25
Full
Full
25
Full
25
Full
25
25
Full
25
25
HA-2539-2
MIN TYP MAX
-
-
-
-
-
-
-
-
-
±10.0
-
-
8
13
20
5
-
1
-
10
1
-
6
6
10
15
-
20
25
6
8
-
-
-
-
-
HA-2539-5
MIN TYP MAX
UNITS
-
-
-
-
-
-
-
-
-
±10.0
-
-
8
13
20
5
-
1
-
10
1
-
6
6
15 mV
20 mV
- µV/oC
20 µA
25 µA
6 µA
8 µA
- k
- pF
-V
- pA/Hz
- nV/Hz
25 10 15
Full 5 -
Full 60 72
25 10 -
25 - 600
Full ±10.0 -
25 ±10 ±20
25 - 30
25 8.7 9.5
- 10 15
-5-
- 60 72
- 10 -
- - 600
- ±10.0 -
- ±10 ±20
- - 30
- 8.7 9.5
- kV/V
-- kV/V
- dB
- V/V
- MHz
-V
- mA
-
- MHz
2









No Preview Available !

HA-2539 Даташит, Описание, Даташиты
HA-2539
Electrical Specifications VSUPPLY = ±15V, RL = 1k, CL < 10pF, Unless Otherwise Specified (Continued)
PARAMETER
TEMP.
(oC)
HA-2539-2
MIN TYP MAX
HA-2539-5
MIN TYP
TRANSIENT RESPONSE (Note 8)
Rise Time
25 - 7 - - 7
Overshoot
25
- 15 -
- 15
Slew Rate
25 550 600 - 550 600
Settling Time: 10V Step to 0.1%
25
- 180 -
- 180
POWER REQUIREMENTS
Supply Current
Full - 20 25 - 20
Power Supply Rejection Ratio (Note 9) Full 60 70 - 60 70
NOTES:
3. RL = 1k, VO = ±10V.
4. VCM = ±10.0V.
5. VO = 90mV.
6. AV = 10.
7.
8.
Full Power Bandwidth guaranteed based on slew rate measurement using:
Refer to Test Circuits section of data sheet.
FPBW
=
-2S---π-l--e-V--w--P----R-E---a-A---t-e-K-- .
9. VSUPPLY = +5V, -15V and +15V, -5V.
10. Guaranteed range for output voltage is ±10V. Functional operation outside of this range is not guaranteed.
MAX
-
-
-
-
25
-
Test Circuits and Waveforms
UNITS
ns
%
V/µs
ns
mA
dB
IN +
-
900
100
OUT
NOTES:
11. VS = ±15V.
12. AV = +10.
13. CL 10pF.
FIGURE 1. TEST CIRCUIT
A
B
Vertical Scale: A = 0.5V/Div., B = 5.0V/Div.
Horizontal Scale: 50ns/Div.
FIGURE 2. LARGE SIGNAL RESPONSE
3
Vertical Scale: Input = 10mV/Div., Output = 50mV/Div.
Horizontal Scale: 20ns/Div.
FIGURE 3. SMALL SIGNAL RESPONSE










Скачать PDF:

[ HA-2539.PDF Даташит ]

Номер в каталогеОписаниеПроизводители
HA-2539600MHz/ Very High Slew Rate Operational AmplifierIntersil Corporation
Intersil Corporation

Номер в каталоге Описание Производители
TL431

100 мА, регулируемый прецизионный шунтирующий регулятор

Unisonic Technologies
Unisonic Technologies
IRF840

8 А, 500 В, N-канальный МОП-транзистор

Vishay
Vishay
LM317

Линейный стабилизатор напряжения, 1,5 А

STMicroelectronics
STMicroelectronics

DataSheet26.com    |    2020    |

  Контакты    |    Поиск