DataSheet26.com

HA5013IB PDF даташит

Спецификация HA5013IB изготовлена ​​​​«Intersil Corporation» и имеет функцию, называемую «Triple/ 125MHz Video Amplifier».

Детали детали

Номер произв HA5013IB
Описание Triple/ 125MHz Video Amplifier
Производители Intersil Corporation
логотип Intersil Corporation логотип 

14 Pages
scroll

No Preview Available !

HA5013IB Даташит, Описание, Даташиты
Data Sheet
HA5013
September 1998
File Number 3654.4
Triple, 125MHz Video Amplifier
The HA5013 is a low cost triple amplifier optimized for RGB
video applications and gains between 1 and 10. It is a
current feedback amplifier and thus yields less bandwidth
degradation at high closed loop gains than voltage feedback
amplifiers.
The low differential gain and phase, 0.1dB gain flatness, and
ability to drive two back terminated 75cables, make this
amplifier ideal for demanding video applications.
The current feedback design allows the user to take
advantage of the amplifier’s bandwidth dependency on the
feedback resistor.
The performance of the HA5013 is very similar to the
popular Intersil HA-5020 single video amplifier.
Pinout
HA5013
(PDIP, SOIC)
TOP VIEW
NC 1
NC 2
NC 3
V+ 4
+IN1 5
-IN1 6
OUT1 7
+-
-
14 OUT2
13 -IN2
12 +IN2
11 V-
10 +IN3
9 -IN3
8 OUT3
Features
• Wide Unity Gain Bandwidth . . . . . . . . . . . . . . . . . 125MHz
• Slew Rate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 475V/µs
• Input Offset Voltage . . . . . . . . . . . . . . . . . . . . . . . . 800µV
• Differential Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.03%
• Differential Phase . . . . . . . . . . . . . . . . . . . . 0.03 Degrees
• Supply Current (Per Amplifier) . . . . . . . . . . . . . . . . 7.5mA
• ESD Protection. . . . . . . . . . . . . . . . . . . . . . . . . . . . 4000V
• Guaranteed Specifications at ±5V Supplies
• Low Cost
Applications
• PC Add-On Multimedia Boards
• Flash A/D Driver
• Color Image Scanners
• CCD Cameras and Systems
• RGB Cable Driver
• RGB Video Preamp
• PC Video Conferencing
Ordering Information
TEMP.
PART NUMBER RANGE (oC)
PACKAGE
PKG.
NO.
HA5013IP
-40 to 85 14 Ld PDIP
E14.3
HA5013IB
-40 to 85 14 Ld SOIC
M14.15
HA5025EVAL
High Speed Op Amp DIP Evaluation Board
1 CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143 | Copyright © Intersil Corporation 1999









No Preview Available !

HA5013IB Даташит, Описание, Даташиты
HA5013
Absolute Maximum Ratings
Thermal Information
Voltage Between V+ and V- Terminals. . . . . . . . . . . . . . . . . . . . 36V
DC Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±VSUPPLY
Differential Input Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10V
Output Current (Note 2) . . . . . . . . . . . . . . . . Short Circuit Protected
ESD Rating (Note 4)
Human Body Model (Per MIL-STD-883 Method 3015.7) . . . . 2000V
Operating Conditions
Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . -40oC to 85oC
Supply Voltage Range (Typical) . . . . . . . . . . . . . . . . . ±4.5V to ±15V
Thermal Resistance (Typical, Note 1)
θJA (oC/W)
PDIP Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
100
SOIC Package . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
120
Maximum Junction Temperature (Die Only, Note 3) . . . . . . . . . 175oC
Maximum Junction Temperature (Plastic Package, Note 3) . . . 150oC
Maximum Storage Temperature Range . . . . . . . . . . -65oC to 150oC
Maximum Lead Temperature (Soldering 10s) . . . . . . . . . . . . 300oC
(SOIC - Lead Tips Only)
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
NOTES:
1. θJA is measured with the component mounted on an evaluation PC board in free air.
2. Output is protected for short circuits to ground. Brief short circuits to ground will not degrade reliability, however, continuous (100% duty cycle)
output current should not exceed 15mA for maximum reliability.
3. Maximum power dissipation, including output load, must be designed to maintain junction temperature below 175oC for die, and below 150oC
for plastic packages. See Application Information section for safe operating area information.
4. The non-inverting input of unused amplifiers must be connected to GND.
Electrical Specifications VSUPPLY = ±5V, RF = 1kΩ, AV = +1, RL = 400Ω, CL 10pF, Unless Otherwise Specified
PARAMETER
TEST CONDITIONS
(NOTE 9)
TEST
LEVEL
TEMP.
(oC) MIN TYP MAX
UNITS
INPUT CHARACTERISTICS
Input Offset Voltage (VIO)
A
25 - 0.8 3
mV
A
Full - - 5
mV
Delta VIO Between Channels
Average Input Offset Voltage Drift
A
Full - 1.2 3.5
mV
B Full - 5 - µV/oC
VIO Common Mode Rejection Ratio
VCM = ±2.5V (Note 5)
A
25 53 -
-
dB
A
Full 50
-
-
dB
VIO Power Supply Rejection Ratio
±3.5V VS ≤ ±6.5V
A
25 60 -
-
dB
A
Full 55
-
-
dB
Input Common Mode Range
Non-Inverting Input (+IN) Current
VCM = ±2.5V (Note 5)
A
Full ±2.5
-
-
V
A
25 - 3 8
µA
A
Full -
- 20
µA
+IN Common Mode Rejection
(+IBCMR
=
1
+RIN
)
+IN Power Supply Rejection
VCM = ±2.5V (Note 5)
±3.5V VS ≤ ±6.5V
A 25 - - 0.15 µA/V
A
Full -
- 0.5
µA/V
A
25
-
- 0.1
µA/V
A
Full -
- 0.3
µA/V
Inverting Input (-IN) Current
A
25, 85
-
4 12
µA
A
-40 - 10 30
µA
Delta - IN BIAS Current Between Channels
A
25, 85
-
6 15
µA
A
-40 - 10 30
µA
2









No Preview Available !

HA5013IB Даташит, Описание, Даташиты
HA5013
Electrical Specifications VSUPPLY = ±5V, RF = 1kΩ, AV = +1, RL = 400Ω, CL 10pF, Unless Otherwise Specified (Continued)
PARAMETER
TEST CONDITIONS
(NOTE 9)
TEST
LEVEL
TEMP.
(oC) MIN TYP MAX
UNITS
-IN Common Mode Rejection
VCM = ±2.5V (Note 5)
A
25
-
- 0.4
µA/V
A
Full -
- 1.0
µA/V
-IN Power Supply Rejection
±3.5V VS ≤ ±6.5V
A
25
-
- 0.2
µA/V
A
Full -
- 0.5
µA/V
Input Noise Voltage
f = 1kHz
B
25
- 4.5 -
nV/Hz
+Input Noise Current
f = 1kHz
B
25
- 2.5 -
pA/Hz
-Input Noise Current
f = 1kHz
B
25
- 25.0 -
pA/Hz
TRANSFER CHARACTERISTICS
Transimpedence
VOUT = ±2.5V (Note 11)
A
25 1.0 -
-
M
A
Full 0.85
-
-
M
Open Loop DC Voltage Gain
RL = 400Ω, VOUT = ±2.5V
A
A
25 70
Full 65
-
-
-
-
dB
dB
Open Loop DC Voltage Gain
RL = 100Ω, VOUT = ±2.5V
A
A
25 50
Full 45
-
-
-
-
dB
dB
OUTPUT CHARACTERISTICS
Output Voltage Swing
RL = 150
A 25 ±2.5 ±3.0 -
A
Full ±2.5 ±3.0
-
V
V
Output Current
Short Circuit Output Current
POWER SUPPLY CHARACTERISTICS
RL = 150
VIN = ±2.5V, VOUT = 0V
B
A
Full ±16.6 ±20.0
Full ±40 ±60
-
-
mA
mA
Supply Voltage Range
A
25 5 - 15
V
Quiescent Supply Current
A Full - 7.5 10 mA/Op Amp
AC CHARACTERISTICS AV = +1
Slew Rate
Note 6
B
25 275 350 -
V/µs
Full Power Bandwidth (Note 7)
B
25 22 28 -
MHz
Rise Time (Note 8)
Fall Time (Note 8)
Propagation Delay (Note 8)
Overshoot
VOUT = 1V, RL = 100
B
25 - 6 -
ns
VOUT = 1V, RL = 100
B
25 - 6 -
ns
VOUT = 1V, RL = 100
B
25 - 6 -
ns
B
25 - 4.5 -
%
-3dB Bandwidth
Settling Time
VOUT = 100mV
B
25 - 125 -
MHz
To 1%, 2V Output Step
B
25 - 50 -
ns
Settling Time
To 0.25%, 2V Output Step
B
25 - 75 -
ns
AC CHARACTERISTICS AV = +2, RF = 681
Slew Rate
Note 6
B
25 - 475 -
V/µs
3










Скачать PDF:

[ HA5013IB.PDF Даташит ]

Номер в каталогеОписаниеПроизводители
HA5013IBTriple/ 125MHz Video AmplifierIntersil Corporation
Intersil Corporation
HA5013IPTriple/ 125MHz Video AmplifierIntersil Corporation
Intersil Corporation

Номер в каталоге Описание Производители
TL431

100 мА, регулируемый прецизионный шунтирующий регулятор

Unisonic Technologies
Unisonic Technologies
IRF840

8 А, 500 В, N-канальный МОП-транзистор

Vishay
Vishay
LM317

Линейный стабилизатор напряжения, 1,5 А

STMicroelectronics
STMicroelectronics

DataSheet26.com    |    2020    |

  Контакты    |    Поиск