|
|
PDF HMN1M8DVN Data sheet ( Hoja de datos )
| Número de pieza | HMN1M8DVN | |
| Descripción | Non-Volatile SRAM MODULE 8Mbit | |
| Fabricantes | Hanbit Electronics | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de HMN1M8DVN (archivo pdf) en la parte inferior de esta página. Total 9 Páginas | ||
|
No Preview Available !
www.DataSheet4U.com
HANBit
HMN1M8DVN
Non-Volatile SRAM MODULE 8Mbit (1024k x 8bit) 40Pin – DIP, 3.3V
Part No. HMN1M8DVN
GENERAL DESCRIPTION
The HMN1M8DVN Nonvolatile SRAM is a 8,388,608-bit static RAM organized as 1,048,576 bytes by 8 bits.
The HMN1M8DVN has a self-contained lithium energy source provide reliable non-volatility coupled with the unlimited
write cycles of standard SRAM and integral control circuitry which constantly monitors the single 3.3V supply for an out-of-
tolerance condition. When such a condition occurs, the lithium energy source is automatically switched on to sustain the
memory until after VCC returns valid and write protection is unconditionally enabled to prevent garbled data. In addition the
SRAM is unconditionally write-protected to prevent an inadvertent write operation. At this time the integral energy source is
switched on to sustain the memory until after VCC returns valid.
The HMN1M8DVN uses extremely low standby current CMOS SRAM’s, coupled with small lithium coin cells to provide
non-volatility without long write-cycle times and the write-cycle limitations associated with EEPROM.
FEATURES
w Access time : 70, 85, 120, 150 ns
w High-density design : 8Mbit Design
w Battery internally isolated until power is applied
w Industry-standard 40-pin 1,024K x 8 pinout
w Unlimited write cycles
w Data retention in the absence of VCC
w 10-years minimum data retention in absence of power
w Automatic write-protection during power-up/power-down
cycles
w Data is automatically protected during power loss
OPTIONS
w Timing
70 ns
85 ns
120 ns
150 ns
MARKING
- 70
- 85
-100
-150
PIN ASSIGNMENT
DU 1
NC 2
NC 3
A18 4
A16 5
A14 6
A12 7
A7 8
A6 9
A5 10
A4 11
A3 12
A2 13
A1 14
A0 15
DQ0 16
DQ1 17
DQ2 18
VSS 19
DU 20
40 DU
39 VCC
38 A19
37 NC
36 A15
35 A17
34 /WE
33 A13
32 A8
31 A9
30 A11
29 /OE
28 A10
27 /CE
26 DQ7
25 DQ6
24 DQ5
23 DQ4
22 DQ3
21 DU
40-pin Encapsulated Package
URL:www.hbe.co.kr
Rev.0.0 (January/ 2003)
1 HANBit Electronics Co.,Ltd
1 page  
HANBit
HMN1M8DVN
READ CYCLE (TA= TOPR, VCCmin ≤ VCC≤ VCCmax )
PARAMETER
SYMBOL CONDITIONS
-70
-85
-120
-150
UNIT
MIN MAX MIN MAX MIN MAX MIN MAX
Read Cycle Time
tRC
70 - 85 - 120 - 150 -
ns
Address Access Time
tACC Output load A - 70 - 85 - 120 - 150 ns
Chip enable access time
tACE Output load A - 70 - 85 - 120 - 150 ns
Output enable to Output valid
tOE Output load A - 35 - 45 - 60 - 70 ns
Chip enable to output in low Z
tCLZ Output load B 5 - 5 - 5 - 10 - ns
Output enable to output in low Z
tOLZ Output load B 5 - 0 - 0 - 5 - ns
Chip disable to output in high Z
tCHZ Output load B 0 25 0 35 0 45 0 60 ns
Output disable to output high Z
tOHZ Output load B 0 25 0 25 0 35 0 50 ns
Output hold from address change
tOH
Output load A 10 - 10 - 10 - 10 -
ns
WRITE CYCLE (TA= TOPR, Vccmin ≤ Vcc ≤ Vccmax )
PARAMETER
SYMBOL CONDITIONS
-70
-85
-120
-150
MIN MAX MIN MAX MIN MAX Min Max
Write Cycle Time
tWC
70 - 85 - 120 - 150 -
Chip enable to end of write
tCW
Note 1
65 - 75 - 100 - 100 -
Address setup time
tAS
Note 2
0-0-0-0-
Address valid to end of write
tAW
Note 1
65 - 75 - 100 - 90 -
Write pulse width
tWP
Note 1
55 - 65 - 85 - 90 -
Write recovery time (write cycle 1)
tWR1
Note 3
5-5-5-5-
Write recovery time (write cycle 2)
tWR2
Note 3
15 - 15 - 15 - 15 -
Data valid to end of write
tDW
30 - 35 - 45 - 50 -
Data hold time (write cycle 1)
tDH1
Note 4
0-0-0-0-
Data hold time (write cycle 2)
tDH2
Note 4
10 - 10 - 10 - 0 -
Write enabled to output in high Z
tWZ
Note 5
0 25 0 30 0 40 0 50
Output active from end of write
tOW
Note 5
5-0-0-5-
NOTE: 1. A write ends at the earlier transition of /CE going high and /WE going high.
2. A write occurs during the overlap of allow /CE and a low /WE. A write begins at the later transition of /CE
going low and /WE going low.
3. Either tWR1 or tWR2 must be met.
4. Either tDH1 or tDH2 must be met.
5. If /CE goes low simultaneously with /WE going low or after /WE going low, the outputs remain in high-
impedance state.
UNI
T
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
URL:www.hbe.co.kr
Rev.0.0 (January/ 2003)
5 HANBit Electronics Co.,Ltd
5 Page | ||
| Páginas | Total 9 Páginas | |
| PDF Descargar | [ Datasheet HMN1M8DVN.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| HMN1M8DV | Non-Volatile SRAM MODULE 8Mbit | Hanbit Electronics |
| HMN1M8DVN | Non-Volatile SRAM MODULE 8Mbit | Hanbit Electronics |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |