DataSheet26.com

HI-8787 PDF даташит

Спецификация HI-8787 изготовлена ​​​​«Holt Integrated Circuits» и имеет функцию, называемую «(HI-8787 / HI-8788) 16-BIT PARALLEL DATA CONVERTED 429&561 SERIAL DATA OUT».

Детали детали

Номер произв HI-8787
Описание (HI-8787 / HI-8788) 16-BIT PARALLEL DATA CONVERTED 429&561 SERIAL DATA OUT
Производители Holt Integrated Circuits
логотип Holt Integrated Circuits логотип 

7 Pages
scroll

No Preview Available !

HI-8787 Даташит, Описание, Даташиты
HI-8787, HI-8788
January 2001
DESCRIPTION
The HI-8787 and HI-8788 are system components for
interfacing 16 bit parallel data to an ARINC 429 bus. They
combine logic and line driver on one chip. The HI-8787 has
an output resistance of 37.5 ohms, and the HI-8788 has
output resistance of 10 ohms to facilitate external lightning
protection circuitry. The technology is analog/digital
CMOS.
Both products offer high speed data bus transactions into a
buffer register. After loading 2 16-bit words, data is
automatically transferred and transmitted. The data rate is
equal to the clock rate. Parity can be enabled in the 32nd
bit. Reset is used to initialize the logic upon startup. Word
gaps are automatically sent.
The part requires +/- 10 volt supplies in addition to a 5 volt
supply.
PIN CONFIGURATION
D4 - 1
N/C - 2
D5 - 3
D6 - 4
D7 - 5
D8 - 6
D9 - 7
D10 - 8
HI-8787PQI
HI-8787PQT
HI-8788PQI
&
HI-8788PQT
24 - TXBOUT
23 - TXAOUT
22 - V-
21 - PARITY ENB
20 - XMT RDY
19 - XMIT CLK
18 - RESET
17 - WRITE
www.DataSheet4U.com
FEATURES
32-Pin Plastic TQFP package
l Automatically converts 16 bit parallel data
to ARINC 429 or 561 data
l High speed data bus interface
l On-chip line driver
l Available in small TQFP package
l Military processing options
(DS8787 Rev. B)
HOLT INTEGRATED CIRCUITS
1
01/01









No Preview Available !

HI-8787 Даташит, Описание, Даташиты
HI-8787, HI-8788
PIN DESCRIPTIONS
PIN SYMBOL FUNCTION
28
1, 3-10,13-15, 29-32
11
12
16
17
18
19
20
21
22
23
24
25
26
27
561 SYNC
Dn
GND
A0
SLP1.5
WRITE
RESET
XMIT CLK
XMT RDY
PARITY ENB
V-
TXAOUT
TXBOUT
561 DATA
V+
VCC
digital output
digital inputs
power supply
digital input
digital input
digital input
digital input
digital input
digital output
digital input
power supply
analog output
analog output
digital output
power supply
power supply
DESCRIPTION
ARINC 561 Sync signal
Parallel 16 bit bus input
Ground
Load address, A0=0 for 1st data load, A0=1 for 2nd data load
Selects the slope of the line driver. High=1.5us
Write strobe. Loads data on rising edge.
Registers and sequencing logic initialized when low
Clock input for the transmitter
Goes high if the buffer register is empty
When high the 32nd bit output is odd parity
-10 volt rail
Line driver output - A side
Line driver output - B side
Serial output for ARINC 561 data
+10 volt rail
+5 volt rail, “one” level out of line driver, inverted for “zero”
FUNCTIONAL DESCRIPTION
The HI-8787 is a parallel to serial converter, which when
loaded with two 16 bit parallel words, outputs the data as a
32 bit serial word. Timing circuitry inserts a 4 bit gap at the
end of each 32 bit word. An input buffer register allows load
operations to take place while the previously loaded word
is being transmitted.
If the PARITY ENB pin is high, the 32nd bit will be a parity
bit, inserted so as to make the 32 bit word have odd parity. If
the PARITY ENB pin is low, the 32nd bit will be the D15 bit
of the 2nd word loaded.
Outputs are provided for both ARINC 429 (TXAOUT and
TXBOUT pins), and ARINC 561 (561 DATA and 561 SYNC
pins) type data.
A low signal applied to the RESET pin resets the HI-8787’s
internal logic so that spurious transmission does not take
place during power-up. The registers are cleared so that a
continuous gap will be transmitted until the first word is
loaded into the transmitter.
Input data can be loaded when the XMT RDY signal is
high, which indicates the input buffer register is empty. The
first 16 bit word is loaded with the A0 input high. The sec-
ond word is loaded with A0 in the low state. Each data word
is loaded into the input buffer register by a low pulse on the
WRITE input. (See figure 1). After the second word has
been loaded, the XMT RDY output goes low. The contents
of the input buffer register are transferred to the output reg-
ister during the fourth bit period of the gap. If the fourth gap
bit period of the previous word has already been transmit-
ted, the contents of the input buffer register will be trans-
ferred to the output shift register during the first bit period af-
ter the second data load, and the XMT RDY output goes
high.
After the output shift register is loaded, the data is shifted
out to the output logic in the order shown in figure 2.
The 561 SYNC output pulses low when the XMIT CLK is
low during the 8th bit of the ARINC transmission.
The XMIT CLK frequency is the same as the data rate.
HOLT INTEGRATED CIRCUITS
2









No Preview Available !

HI-8787 Даташит, Описание, Даташиты
WRITE
A0
XMIT CLK
status &
control
logic
DATA 16
BUS
16 to 32 bit
mux
32
32 bit
buffer
register
32
32 bit
shift
register
SLP1.5
word gap
counter
line
driver
XMT RDY
TXAOUT
TXBOUT
bit
counter
output
logic
561 SYNC
561 DATA
PARITY ENB
Figure 1. Block Diagram
FUNCTIONAL DESCRIPTION (Cont.)
The HI-8787 and HI-8788 have an on-chip line driver de-
signed to directly drive the ARINC 429 bus. The two ARINC
outputs (TXAOUT and TXBOUT) provide a differential volt-
age to produce a +10 volt One, a -10 volt Zero, and a 0 volt
Null. The slope of the ARINC outputs is controlled by the
SLP1.5 pin. If SLP1.5 is high, the output rise and fall time is
nominally 1.5µs. .If SLP1.5 is set low, the rise and fall times
are 10µs.
The HI-8787 has 37.5 ohms in series with each line driver
output. The HI-8788 has 10.0 ohms in series. The HI-8788
is for applications where external series resistance is
needed, typically for lightning protection devices.
A0 Load Data Bus
1 Word 1 D0 - D15
0 Word 2 D0 - D15
ARINC Bits
ARINC 1 - ARINC 16
ARINC 17 - ARINC 32
Figure 2. Order of transmitted data
HOLT INTEGRATED CIRCUITS
3










Скачать PDF:

[ HI-8787.PDF Даташит ]

Номер в каталогеОписаниеПроизводители
HI-8783(HI-8783 - HI-8785) 8 bit parallel data converted to 429 & 561 serial data outHolt Integrated Circuits
Holt Integrated Circuits
HI-8784(HI-8783 - HI-8785) 8 bit parallel data converted to 429 & 561 serial data outHolt Integrated Circuits
Holt Integrated Circuits
HI-8785(HI-8783 - HI-8785) 8 bit parallel data converted to 429 & 561 serial data outHolt Integrated Circuits
Holt Integrated Circuits
HI-8787(HI-8787 / HI-8788) 16-BIT PARALLEL DATA CONVERTED 429&561 SERIAL DATA OUTHolt Integrated Circuits
Holt Integrated Circuits

Номер в каталоге Описание Производители
TL431

100 мА, регулируемый прецизионный шунтирующий регулятор

Unisonic Technologies
Unisonic Technologies
IRF840

8 А, 500 В, N-канальный МОП-транзистор

Vishay
Vishay
LM317

Линейный стабилизатор напряжения, 1,5 А

STMicroelectronics
STMicroelectronics

DataSheet26.com    |    2020    |

  Контакты    |    Поиск