SC471 Datasheet PDF - Semtech Corporation
| Part Number | SC471 | |
| Description | Synchronous Buck Controller | |
| Manufacturers | Semtech Corporation | |
| Logo |  |
|
|
There is a preview and SC471 download ( pdf file ) link at the bottom of this page. Total 27 Pages | ||
Preview 1 page No Preview Available !
PPOOWWEERRMMAANNAAGGEEMMEENNTT
SC471/SC471A
Synchronous Buck Controller with
Multi-Level VOUT Transition Support
Description
Features
The SC471/A is a versatile, constant on-time synchronous
buck, pseudo-fixed-frequency, PWM controller intended for
notebook computers and other battery operated portable
devices. The SC471/A contains all the features needed to
provide cost-effective control of system elements needing
voltage slewing. Two integrated switches provide four
resistor-programmable DC output voltages, controlled by
the G0 and G1 inputs.
www.DataSheet4U.com
The output voltage is adjustable from 0.75V to 5V.
Additional features for each output include cycle-by-cycle
current limit, voltage soft-start, under-voltage protection,
programmable over-current protection, soft shutdown,
automatic power save and non-overlapping gate drive.
The SC471/A provides an enable input and a power good
output which is automatically blanked during output
voltage transitions.
The constant on-time topology provides fast dynamic
response. The excellent transient response means that
SC471/A based solutions require less output capacitance
than competing fixed-frequency converters. Switching
frequency is constant until a step in load or line voltage
occurs, at which time the pulse density and frequency
will increase or decrease to counter the change in
output voltage. After the transient event, the controller
frequency returns to steady state operation. At light loads,
the automatic power save mode reduces the SC471/A
frequency for improved efficiency.
VOUT Programmable 0.75V to 5.25V with Integrated
Transition Support
VBAT Range 3V to 25V
Soft Shutoff at Output
Current Sense Using Low-side RDS(ON) or Resistor
Sensing
Adjustable Cycle-by-Cycle Valley Current Limit
325kHz Fixed-Frequency
Constant On-Time for Fast Dynamic Response and
Reduced Output Capacitance
Automatic Smart Power Save†
Internal Soft-Start
Over-Voltage/Under-Voltage Fault Protection
Power Good Output with Transition Blanking
1μA Typical Shutdown Current
500μA Typical Operating Current
Tiny 3×3mm, 16 Pin MLPQ Package
Low External Part Count
Industrial Temperature Range
0.85% Internal Reference
1A/3A Non-Overlapping Gate Drive with
SmartDriver™ Technology
High Efficiency > 90%
This Product is Fully WEEE and RoHS Compliant
†Patent Pending
Applications
Notebook/Sub-Notebook Graphics Voltage
Controllers
Tablet PCs
Embedded Applications
September 12, 2006
1
www.semtech.com
|
| |
 
SC471/SC471A
POWER MANAGEMENT
Electrical Characteristics (continued)
Parameter
Conditions
25°C
Min Typ Max
-40° to 85°C
Min Max
Units
Fault Protection (continued)
Output Under-Voltage Fault
FB with Respect to Nominal
Steady-State
Over-Voltage Fault
www.DataSheet4U.com
Steady-State
Over-Voltage Fault Delay
FB with Respect to Nominal
FB Forced 50mV Above
Over-Voltage Fault Threshold
G0/G1 Transition
Over-Voltage Fault
FB with Respect to Nominal;
valid for 32 cycles after G0/G1
Transition
Smart Power Save Threshold FB with Respect to Nominal
Over-Temperature Shutdown(1) Latching, >10°C Hysteresis
-30
+20
5
+50
+8
160
-35 -25 %
+17 +23 %
μs
%
%
°C
Logic Inputs/Outputs
Logic Input High Voltage
Logic Input Low Voltage
EN Input Bias Current
G0, G1 Input Bias Current
Power Good Output
Low Voltage
EN, G0, G1
EN, G0, G1
EN = 5V
G0, G1 = 5V
RPWRGD = 10kΩ to VCC
1.2 V
0.4 V
-1 +1 μA
5 0 10 μA
0.4 V
Gate Drivers
Shoot-Through
Protection Delay(1)
DH or DL Rising
30
ns
DL Pull-Down Resistance
0.8 1.6 Ω
DL Sink Current
DL Pull-Up Resistance
VDL = 2.5V
3.1
2
A
4Ω
DL Source Current
DH Pull-Down Resistance
VDL = 2.5V
BST - LX = 5V
1.3
2
A
4Ω
DH Pull-Up Resistance(2)
BST - LX = 5V
2
4Ω
DH Sink/Source Current
VDH = 2.5V
1.3
A
Notes:
1) Guaranteed by design.
2) Semtech’s SmartDriver™ FET drive first pulls DH high with a pull-up resistance of 10Ω (typical) until LX = 1.5V (typical). At this point, an ad-
ditional pull-up device is activated, reducing the resistance to 2Ω (typical). This negates the need for an external gate or boost resistor.
© 2006 Semtech Corp.
5
www.semtech.com
Preview 5 Page |
Part DetailsOn this page, you can learn information such as the schematic, equivalent, pinout, replacement, circuit, and manual for SC471 electronic component. |
| Information | Total 27 Pages | |
| Link URL | [ Copy URL to Clipboard ] | |
| Download | [ SC471.PDF Datasheet ] | |
Share Link :
Electronic Components Distributor
|
An electronic components distributor is a company that sources, stocks, and sells electronic components to manufacturers, engineers, and hobbyists. |
| SparkFun Electronics | Allied Electronics | DigiKey Electronics | Arrow Electronics |
| Mouser Electronics | Adafruit | Newark | Chip One Stop |
Featured Datasheets
| Part Number | Description | MFRS |
| SC470 | The function is Synchronous Buck Controller. Semtech Corporation | |
| SC471 | The function is Synchronous Buck Controller. Semtech Corporation | |
| SC471A | The function is Synchronous Buck Controller. Semtech Corporation | |
Semiconductors commonly used in industry:
1N4148 |
BAW56 |
1N5400 |
NE555 | | ||
Quick jump to:
SC47
1N4
2N2
2SA
2SC
74H
BC
HCF
IRF
KA | ||