|
|
PDF S6708 Data sheet ( Hoja de datos )
| Número de pieza | S6708 | |
| Descripción | STR-S6708 | |
| Fabricantes | Allegro MicroSystems | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de S6708 (archivo pdf) en la parte inferior de esta página. Total 8 Páginas | ||
|
No Preview Available !
STR-S6707 THRU
STR-S6709
OFF-LINE SWITCHING REGULATORS
– WITH BIPOLAR SWITCHING TRANSISTOR
The STR-S6707, STR-S6708, and STR-S6709 are specifically
designed to meet the requirement for increased integration and reliabil-
COLLECTOR 1
ity in off-line quasi-resonant flyback converters. These devices incorpo-
rate the primary control and proportional drive circuit with a third-
COMMON 2
www.DataSheet4U.com
BASE 3
TSINK 4
DRIVE 5
COVER-CURRENT
PROTECTION
6
UFDBK 7
D YINHIBIT 8
O LVIN 9
DRIVE
OSC.
FAULT
S
FAULT
LATCH
R
REF.
UVLO
R NDwg.PK-001
P E OABSOLUTE MAXIMUM RATINGS
DSupply Voltage, VIN ........................... 15 V
E COutput Voltage, VCEX ....................... 850 V
NVEBO ................................................ 7 V
U EContinuous Output Current,
IC .......................................... See Table
IN R1 ms Single-Pulse Output Current,
T EICM ........................................ See Table
FSink Current, IS......................... See Table
NDrive Current, ID .......................... -700 mA
EFeedback Current, IFDBK ................. 20 mA
O RInhibit Voltage, VINH ........................... 15 V
COver-Current Protection Voltage Range,
RVOCP ............................................ ±3.5 V
IS OInsulation Voltage,VWM(RMS) ........... 2000 V
D FPackage Power Diss., PD ........ See Graph
generation high-voltage bipolar switching transistor.
Crucial system parameters such as maximum ON time and OFF
time are fixed during manufacture. Local control circuit decoupling and
layout are optimized within each device.
Cycle-by-cycle current limiting, under-voltage lock-out with hyster-
esis, over-voltage protection, and thermal shutdown protect these
devices during all normal and overload conditions. Over-voltage
protection and thermal shutdown are latched after a short delay. A
versatile triple-level inhibit circuit includes the OFF time synchronization
required to establish quasi-resonant operation. The inhibit function has
also been expanded to initiate operation in stand-by mode in which the
power supply delivers a small fraction of the steady-state output power.
The dual requirements of dielectric isolation and low transient thermal
impedance and steady-state thermal resistance are satisfied in an over-
molded single-in-line power package.
Proven in substantial volumes, these devices and their fixed-
frequency counterparts represent a significant advance in off-line SMPS
reliability growth and integration.
FEATURES
s Quasi-Resonant Operation for Low EMI and High Efficiency
s Output Power to 220 W
s Low-Power Output Standby Mode
s Pulse-by-Pulse Over-Current Protection
s Latched Over-Voltage and Thermal Protection
s Third-Generation Switching Transistor with Proportional Drive
s Maximum ON Time and Off Time Set During Manufacture
s Internal Under-Voltage Lockout with Hysteresis
s Over-Molded SIP with Integral Isolated Heat Spreader
—Output Junction Temperature, TJ .. +150°C
Internal Frame Temperature, TF ... +125°C
Always order by complete part number:
Max. Cont.
Peak
Max. Sink
Operating Temperature Range,
Part Number Current, IC
Current, ICM Current, IS
TA ............................... -20°C to +125°C
STR-S6707
6A
12 A
1.5 A
Storage Temperature Range,
STR-S6708
7.5 A
15 A
1.5 A
Tstg ............................. -40°C to +125°C
STR-S6709
10 A
20 A
2A
™
1 page  
STR-S6707 THRU STR-S6709
OFF-LINE
QUASI-RESONANT FLYBACK
SWITCHING REGULATORS
TYPICAL QUASI-RESONANT FLYBACK CONVERTER
WARNING: lethal potentials are present. See text.
www.DataSheet4U.com
+
9
7
R
SQ
8
+
+
+
+
5
4
3
1
2
6
5
+ OUTPUT
+
VOLTAGE
SENSE
Ð OUTPUT
Dwg. EK-004A
APPLICATIONS INFORMATION
WARNING Ñ These devices are designed to be operated at lethal voltages and energy levels. Circuit
designs that embody these components must conform with applicable safety requirements. Precau-
tions must be taken to prevent accidental contact with power-line potentials. Do not connect
grounded test equipment.
The use of an isolation transformer is recommended during circuit development and breadboarding.
Recommended mounting hardware torque:
4.34 Ð 5.79 lbf¥ft (6 Ð 8 kg¥cm or 0.588 Ð 0.784 Nm).
Recommended metal-oxide-filled, alkyl-degenerated oil base, silicone grease:
Dow Corning 340, or equivalent
5 Page | ||
| Páginas | Total 8 Páginas | |
| PDF Descargar | [ Datasheet S6708.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| S6705MG | Infrared Laser Diode |  Roithner Lasertechnik |
| S6707 | STRS6707 / STR-S6707 | Allegro MicroSystems |
| S6708 | STR-S6708 | Allegro MicroSystems |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |