DataSheet26.com

NFS110-7924J PDF даташит

Спецификация NFS110-7924J изготовлена ​​​​«Emerson» и имеет функцию, называемую «AC-DC / 86W - 135W Medical».

Детали детали

Номер произв NFS110-7924J
Описание AC-DC / 86W - 135W Medical
Производители Emerson
логотип Emerson логотип 

5 Pages
scroll

No Preview Available !

NFS110-7924J Даташит, Описание, Даташиты
Embedded Power for
Business-Critical Continuity
NSeFrSi1es10 Medical
Single and
quad output
Rev. 12.29.08_139
NFS110-M Series
 of 5
Total Power: 80 - 110 W
Input Voltage: 90 - 253 Vac
127 - 357 Vdc
# of Outputs: Single, quad
Special Features
7.0 x 4.25 x 1.8 inch package
Medical, dental and
laboratory applications
Overvoltage and short circuit
protection
110 W with 20 CFM
UL, VDE and CSA safety
approvals
EN60601-1 and UL2601
medical approvals
Available RoHS compliant
2 year warranty
Safety
VDE0805/EN60601-1/
IEC601/IEC1010
File No. 10401-3336-1049
Licence No. 2874
UL2601 File No. E147937
CSA C22.2 No. 125
File No. LR41062C
Electrical Specifications
Output
Voltage adjustability:
Line regulation:
Overshoot/undershoot:
Temperature coefficient:
Overvoltage protection:
Output power limit:
+5.1 V o/p on multi’s
5.1 V single output
12 V single output
15 V single output
24 V single output
LL to HL, FL
All outputs on all units
At turn-on no lead
All outputs
Multi o/p 5.1 V only
5.1 V single
12 V single
15 V single
24 V single
Primary power
limited
Short circuit protection:
Input
Input voltage range:
Input frequency range:
Input surge current:
Safety ground leakage current:
110 Vac. 50 Hz
230 Vac. 50 Hz
132 Vac
264 Vac
±3.0%
±3.0%
12-14 V
15-18 V
24-30 V
± 0.1% max.
0%
±0.02% / °C
6.25 V ± 0.75 V
6.25 V ± 0.75 V
15.75 V ± 1.0 V
22 V ± 1.5 V
33 V ± 2.5 V
Pin max. 160 W
Pout min. 110 W
Burst mode operation
90-253 Vac
127-357 Vdc
47-440 Hz
17 A
25 A
50 µA
100 µA
All specifications are typical at nominal input, full load at
25 °C unless otherwise stated









No Preview Available !

NFS110-7924J Даташит, Описание, Даташиты
Embedded Power for
Business-Critical Continuity
EMC Characteristics
Conducted emissions:
Radiated emissions:
ESD air:
ESD contact:
Surge:
Fast transients:
Radiated immunity:
Conducted immunity:
General Specifications
Hold-up time:
Efficiency:
Isolation voltage:
Approvals and standards:
(see note 12)
Weight:
MTBF (@25 ºC)
EN55022, FCC part 15
EN55022, FCC part 15
EN61000-4-2, level 3
EN61000-4-2, level 4
EN61000-4-3, level 3
EN61000-4-4, level 3
EN61000-4-5, level 3
EN61000-4-6, level 3
Level A
Level A
Perf. criteria 1
Perf. criteria 1
Perf. criteria 1
Perf. criteria 1
Perf. criteria 2
Perf. criteria 2
110 Vac @ 80 W
110 Vac @ 110 W
230 Vac @ 80 W
230 Vac @ 110 W
Multiple outputs
+5.1 V single
12 V and 15 V singles
24 V single
Input/output
Input/chassis
Singles
Multiple outputs
MIL-HDBK-217E
35 ms
17 ms
140 ms
100 ms
70% typical
70% typical
72% typical
75% typical
4000 Vac
1500 Vac
VDE0750, IEC60601, IEC1010, UL2601,
CSA C22.2 No. 125
550 g (19.4 oz)
600 g (21.2 oz)
125,000 hours min.
Rev. 12.29.08_139
NFS110-M Series
 of 5
Environmental Specifications
Thermal performance:
Operating, see curve
0° C to +70 °C
(See notes 9, 10)
Relative humidity:
Altitude:
Vibration (See Note 11):
Non-operating
-40 °C to +85 °C
0 °C to 50 °C amb. convection cooled 80 W
+50 °C to +70 °C,
amb. convection cooled
Derate 2 W/°C
0 °C to +50 °C, 20 CFM forced air
110 W
+50 °C to +70 °C, 20CFM forced air Derate 2.75 W/°C
Peak, 0 °C to +50 °C, max. 60 seconds 110W
Non-condensing
5% to 95% RH
Operating
10,000 feet max.
Non-operating
40,000 feet max.
5-500 Hz
2.4 G rms peak









No Preview Available !

NFS110-7924J Даташит, Описание, Даташиты
Embedded Power for
Business-Critical Continuity
EMC Characteristics
Output
Voltage
+5.1 V
+12 V
–12 V
–5 V
+5.1 V (IA)
+24 V (IB) (6)
+12 V
–12 V
12 V
15 V
24 V
Max (1)
8A
4.5 A
0.5 A
0.5 A
8A
3.5 A
4.5 A
0.5 A
7A
5A
3.5 A
Output Currents
Peak (2)
20 A
9A
1.5 A
1.5 A
20 A
4.5 A
9A
1.5 A
9A
7.3 A
4.5 A
Fan (3)
10 A
5A
1A
1A
10 A
4.5 A
5A
1A
9A
7.3 A
4.5 A
Rev. 12.29.08_139
NFS110-M Series
 of 5
Ripple (4)
50 mV
120 mV
120 mV
50 mV
50 mV
240 mV
120 mV
120 mV
120 mV
150 mV
240 mV
Total
Regulation (5)
Mo��d�e�l�N�u�m�b�e��r�s� (13, 14, F)
±2.0%
NFS110-7901PJ
±3.0%
±3.0%
±3.0%
±2.0%
NFS110-7902PJ
+10/–5.0%
±3.0%
±3.0%
±2.0%
NFS110-7912J (7,8)
±2.0%
NFS110-7915J (7,8)
±2.0%
NFS110-7924J (7,8)
Notes
1 Convection cooled, 80 W maximum.
2 Peak outputs lasting less than 60 seconds with duty cycle less than 10%. Total
peak power must not exceed 110 W.
3 Forced air, 20 CFM at 1 atmosphere, 110 W maximum.
4 Figure is peak-to-peak. Output ripple is measured across a 50 MHz bandwidth
using a 12 inch twisted pair terminated with a 47 µF capacitor.
5 Total regulation is defined at the static output regulation at 25 °C, including
initial tolerance, line voltage within stated limits and output voltages adjusted
to their factory settings. Also for NFS110-7902PJ, for 24 V output stated
regulation IA / IB ² 5. This output will maintain ±5.0% regulation if
IA ² 5 A, where IA = +5.1 V output current and IB = +24 V output current.
6 Single output models have floating outputs which may be referenced as either
positive or negative. Higher voltage supplies, may be adjusted over a wide
output voltage range, as long as the total output power does not exceed 80
Watts (natural convection) or 110 Watts (forced air).
7 Power fail detect not available on single output models.
8 Derating curve is application specific for ambient temperatures > 50 °C,
for optimum reliability no part of the heatsink should exceed 90 °C and no
semiconductor case temperature should exceed 100 °C.
9 Caution: Allow a minimum of 1 second after disconnecting the power when
making thermal measurements.
10 The user should read the PSU installation instructions in conjunction with the
relevant national safety regulations in order to ensure compliance.
11 Three orthogonal axes, random vibration, 10 minute test for each axis.
12 This product is only for inclusion by professional installers within other
equipment and must not be operated as a stand alone product.
13 The ‘J’ suffix indicates that these parts are Pb-free (RoHS 6/6) compliant. TSE
RoHS 5/6 (non Pb-free) compliant versions may be available on special request,
please contact your local sales representative for details.
14 NOTICE: Some models do not support all options. Please contact your local
Emerson Network Power representative or use the on-line model number
search tool at http://www.powerconversion.com to find a suitable alternative.
NFS110-7901PJ
NFS110-7902PJ
NFS110-7905J
NFS110-7912J
NFS110-7915J
NFS110-7924J
Transient Response
+5.1 V (7.5-10 A)
+12 V (2.5-5 A)
-12 V (0.5-1 A)
-5 V (0.5-1 A)
+5.1 V (7.5-10 A)
+12 V (2.5-5 A)
-12 V (0.5-1 A)
24 V (1.5-3 A)
+5.1 V (10-20 A)
+12 V (4.5-9 A)
+15 V (3.65-7.3 A)
+24 V (2.25-4.5 A
150 mV peak,
1 ms recovery
100 mV peak,
0.5 ms recovery
100 mV peak,
0.5 ms recovery
100 mV peak,
0.5 ms recovery
150 mV peak,
1 ms recovery
100 mV peak,
0.5 ms recovery
100 mV peak,
0.5 ms recovery
300 mV peak,1
ms recovery
250 mV peak,
1 ms recovery
360 mV peak,
1 ms recovery
450 mV peak,
1 ms recovery
720 mV peak,
1 ms recovery










Скачать PDF:

[ NFS110-7924J.PDF Даташит ]

Номер в каталогеОписаниеПроизводители
NFS110-7924JAC-DC / 86W - 135W MedicalEmerson
Emerson

Номер в каталоге Описание Производители
TL431

100 мА, регулируемый прецизионный шунтирующий регулятор

Unisonic Technologies
Unisonic Technologies
IRF840

8 А, 500 В, N-канальный МОП-транзистор

Vishay
Vishay
LM317

Линейный стабилизатор напряжения, 1,5 А

STMicroelectronics
STMicroelectronics

DataSheet26.com    |    2020    |

  Контакты    |    Поиск