DataSheet26.com

HIP5016IS PDF даташит

Спецификация HIP5016IS изготовлена ​​​​«Intersil Corporation» и имеет функцию, называемую «7V/ 7A SynchroFET Complementary Drive Synchronous Half-Bridge».

Детали детали

Номер произв HIP5016IS
Описание 7V/ 7A SynchroFET Complementary Drive Synchronous Half-Bridge
Производители Intersil Corporation
логотип Intersil Corporation логотип 

6 Pages
scroll

No Preview Available !

HIP5016IS Даташит, Описание, Даташиты
Data Sheet
HIP5015, HIP5016
June 1996
File Number 4142
7V, 7A SynchroFET™ Complementary
Drive Synchronous Half-Bridge
Designed with the Pentium® in mind, the Intersil SynchroFET
family provides a new approach for implementing a
synchronous rectified buck switching regulator. The
SynchroFET™ replaces two power DMOSs, a Schottky diode,
two gate drivers and synchronous control circuitry. The
complementary drive circuit turns the upper FET on and the
lower FET off when the input from the PWM is high. When the
input from the PWM goes low the upper FET turns off and the
lower FET turns on. The HIP5016 has a PWM pin that inverts
the relationship from the input to PHASE. This architecture
allows the designer to utilize a low cost single-ended PWM
controller in either a current or voltage mode configuration. The
SynchroFET operates in continuous conduction mode reducing
EMI constraints and enabling high bandwidth operation.
Several features ensure easy start-up. First, the supply currents
stay below specification as the supply voltages ramp up; no
unexpected surges occur that might perturb a soft-start or
deplete a charge-pump. Second, any power-up sequence of
the VCC, VIN, or PWM pins can be used without causing large
currents. Third, the chip operates when VCC is greater than 2V
so VCC can be created from a charge pump powered from VIN.
Ordering Information
TEMP.
PART NUMBER RANGE (oC)
PACKAGE
PKG.
NO.
HIP5015IS
-40 to 85 7 Ld Gullwing SIP Z7.05B
HIP5015IS1
-40 to 85 7 Ld Staggered
Vertical SIP
Z7.05C
HIP5016IS
-40 to 85 7 Ld Gullwing SIP Z7.05B
HIP5016IS1
-40 to 85 7 Ld Staggered
Vertical SIP
Z7.05C
Pinouts
HIP5015IS1, HIP5016IS1 (SIP - VERTICAL)
TOP VIEW
GND (TAB)
7 NC
6 NC
5 PWM (HIP5015), PWM (HIP5016)
4 GND
3 VCC
2 VIN
1 PHASE
FRONT ROWS = PINS 1,3,5,7
BACK ROWS = PINS 2,4,6
Pentium® is a registered trademark of Intel Corporation.
SynchroFET™ is a trademark of Intersil Corporation.
Features
• Complementary Drive, Half-Bridge Power NMOS
• Use With Low-Cost Single-Output PWM Controllers
• Improve Efficiency Over Conventional Buck Converter with
Schottky Clamp
• Minimum Deadtime Provided by Adaptive Shoot-Through
Protection Eliminates External Schottky
• Grounded Case for Low EMI and Simple Heatsinking
• Low Operating Current
• Frequency Exceeding 1MHz
• Dual Polarity Input Options
• All Pins Surge Protected
Applications
• 5V to 3.3V Synchronous Buck Converters
• 3.3V to 2.9V Synchronous Buck Converters
• Pentium Power Supplies
• Bus Terminations (BTL and GTL)
• Drive 5V Motors Directly from Microprocessor
Typical Application Block Diagram
+12V
+5V
VCC
VIN
PWM
CONTROLLER
PWM
CONTROL
PHASE
+3.3V
HIP5015
GND
SYNCHRONOUS RECTIFIED BUCK CONVERTER
GND
(TAB)
HIP5015IS, HIP5016IS (SIP - GULLWING)
TOP VIEW
7 NC
6 NC
5 PWM (HIP5015), PWM (HIP5016)
4
3 VCC
2 VIN
1 PHASE
2-8 CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
http://www.intersil.com or 407-727-9207 | Copyright © Intersil Corporation 1999









No Preview Available !

HIP5016IS Даташит, Описание, Даташиты
HIP5015, HIP5016
Non-Inverting SynchroFET Block Diagram
HIP5015
VCC
DRIVER
PWM
BUFFER
VCC
ADAPTIVE
SHOOT-THROUGH
PROTECTION
DRIVER
Inverting SynchroFET Block Diagram
VCC
HIP5016
DRIVER
PWM
BUFFER
VCC
ADAPTIVE
SHOOT-THROUGH
PROTECTION
DRIVER
VIN
PHASE
GND
VIN
PHASE
GND
2-9









No Preview Available !

HIP5016IS Даташит, Описание, Даташиты
HIP5015, HIP5016
Absolute Maximum Ratings
Supply Voltage, VCC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +16V
Input Voltage VIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +7V
IPHASE, IVIN, IGND . . . . . . . . . . . . . . . . . . . . . 7A (Repetitive Peak)
PWM Input . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -4V to +16V
ESD Classification . . . . . . . . . . . . . . . . . . . . . . . . . . . . Class 3 (4kV)
Lead Temperature (Soldering 10s) (Lead Tips Only). . . . . . . 300oC
Storage Temperature Range . . . . . . . . . . . . . . . . . . -65oC to 150oC
Junction Temperature Range . . . . . . . . . . . . . . . . . . -40oC to 150oC
Operating Conditions
Supply Voltage, VCC . . . . . . . . . . . . . . . . . . . . . . . . . . . +12V, ±20%
Input Voltage VIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0V to 5.5V
Supply Voltage, VCC, minimum for charge-pumped start-up . . . .+4.0V
Thermal Information (Typical)
Package
θJC ††
(oC/W)
0
θJA (oC/W)
123
3†††
SIP (IS). . . . . 2
55 30 25 24 18
SIP (IS1). . . . 2 55 - - - -
Versus additional square inches of 1 ounce copper on the
printed circuit board.
†† θJC is typical with an infinite heatsink.
††† 200 linear feet per minute of air flow.
IPHASE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5A
IVIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4A
IGND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3A
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the recommended operating conditions of this specification is not implied.
Electrical Specifications
PARAMETER
rDS(ON) Upper MOSFET
rDS(ON) Lower MOSFET
VIN Operating Current
VIN Quiescent Current
VCC Operating Current
VCC Quiescent Current (HIP5015)
VCC Quiescent Current (HIP5015)
VCC Quiescent Current (HIP5016)
VCC Quiescent Current (HIP5016)
Low Level PWM Input Voltage
High Level PWM Input Voltage
PWM Input Voltage Hysteresis
Input Pulldown Resistance (HIP5015)
Input Pullup Resistance (HIP5016)
SYMBOL
RDSU
RDSL
IVINO
IVIN
ICCO
ICCIH
ICCIL
ICCNIH
ICCNIL
VIL
VIH
VIHYS
RPWM
RPWM
TEST CONDITIONS
VCC = 12V, VIN = 5V
VCC = 12V, VIN = 5V
VIN = 5V, No Load, 500kHz
PWM or PWM = VCC or GND
VCC = 12V, 500kHz
PWM = VCC
PWM = GND
PWM = VCC
PWM = GND
TJ = 25oC
MIN TYP MAX
- 68 78
- 72 82
- 1.8 4
- 0.1 10
- 4.3 7
- 40 -
- 0.1 10
- 0.1 10
- 100 -
- 1.8 -
- 2.1 -
- 0.3 -
- 220 -
- 220 -
TJ = - 40oC
TJ = +150oC
MIN MAX UNITS
- 130 m
- 136 m
- 5 mA
- 100 µA
- 9 mA
- 300 µA
- 100 µA
- 100 µA
- 300 µA
1- V
-3V
--V
100 400 k
100 400 k
Switching Specifications
PARAMETER
Upper Device Turn-Off Delay
Lower Device Turn-Off Delay
Dead Time
Phase Rise-Time
Phase Fall-Time
SYMBOL
TEST CONDITIONS
tPHL
tPLH
tDT
tr
tf
VCC = 12V, IPHASE = -0.5A
VCC = 12V, IPHASE = +0.5A
VCC = +12V, IPHASE = -0.5A
VCC = 12V, IPHASE = -0.5A
VCC = 12V, IPHASE = +0.5A
TJ = 25oC
MIN TYP MAX
TTJJ==+-14500ooCC
MIN MAX
UNITS
- 30 50 - 80 ns
- 30 50 - 80 ns
- 10 - - - ns
- 20 - - - ns
- 20 - - - ns
2-10










Скачать PDF:

[ HIP5016IS.PDF Даташит ]

Номер в каталогеОписаниеПроизводители
HIP5016IS7V/ 7A SynchroFET Complementary Drive Synchronous Half-BridgeIntersil Corporation
Intersil Corporation
HIP5016IS17V/ 7A SynchroFET Complementary Drive Synchronous Half-BridgeIntersil Corporation
Intersil Corporation

Номер в каталоге Описание Производители
TL431

100 мА, регулируемый прецизионный шунтирующий регулятор

Unisonic Technologies
Unisonic Technologies
IRF840

8 А, 500 В, N-канальный МОП-транзистор

Vishay
Vishay
LM317

Линейный стабилизатор напряжения, 1,5 А

STMicroelectronics
STMicroelectronics

DataSheet26.com    |    2020    |

  Контакты    |    Поиск