DataSheet26.com

HC-5509B PDF даташит

Спецификация HC-5509B изготовлена ​​​​«Intersil Corporation» и имеет функцию, называемую «SLIC Subscriber Line Interface Circuit».

Детали детали

Номер произв HC-5509B
Описание SLIC Subscriber Line Interface Circuit
Производители Intersil Corporation
логотип Intersil Corporation логотип 

10 Pages
scroll

No Preview Available !

HC-5509B Даташит, Описание, Даташиты
HC-5509B3999-003
SEMICONDUCTOR
March 1996
SLIC
Subscriber Line Interface Circuit
Features
• DI Monolithic High Voltage Process
• Compatible with Worldwide PBX and CO Performance
Requirements
• Controlled Supply of Battery Feed Current with Pro-
grammable Current Limit
• Operates with 5V Positive Supply (VB+)
• Internal Ring Relay Driver and a Utility Relay Driver
• High Impedance Mode for Subscriber Loop
• High Temperature Alarm Output
• Low Power Consumption During Standby Functions
• Switch Hook, Ground Key, and Ring Trip Detection
• Selective Power Denial to Subscriber
• Voice Path Active During Power Denial
• On-Chip Op Amp for 2-Wire Impedance Matching
Applications
• Solid State Line Interface Circuit for PBX or Central
Office Systems, Digital Loop Carrier Systems
• Hotel/Motel Switching Systems
• Direct Inward Dialing (DID) Trunks
• Voice Messaging PBXs
• High Voltage 2-Wire/4-Wire, 4-Wire/2-Wire Hybrid
Ordering Information
PART NUMBER
HC9P5509B3999-003
TEMP.
RANGE (oC) PACKAGE
0 to +75 28 Ld SOIC
PKG.
NO.
M28.3
Description
The HC-5509B3999-003 telephone Subscriber Line Inter-
face Circuit integrates most of the BORSCHT functions on a
monolithic IC. The device is manufactured in a Dielectric Iso-
lation (DI) process and is designed for use as a high voltage
interface between the traditional telephone subscriber pair
(Tip and Ring) and the low voltage filtering and cod-
ing/decoding functions of the line card. Together with a sec-
ondary protection diode bridge and “feed” resistors, the
device will withstand 1000V lightning induced surges, in
plastic packages. The SLIC also maintains specified trans-
mission performance in the presence of externally induced
longitudinal currents. The BORSCHT functions that the SLIC
provides are:
Battery Feed with Subscriber Loop Current Limiting
Overvoltage Protection
Ring Relay Driver
Supervisory Signaling Functions
Hybrid Functions (with External Op-Amp)
Test (or Battery Reversal) Relay Driver
In addition, the SLIC provides selective denial of power to
subscriber loops, a programmable subscriber loop current
limit from 20mA to 60mA, a thermal shutdown with an alarm
output and line fault protection. Switch hook detection, ring
trip detection and ground key detection functions are also
incorporated in the SLIC device.
The HC-5509B3999-003 SLIC is ideally suited for line card
designs in PBX and CO systems, replacing traditional
transformer solutions.
Pinout
HC-5509B3999-003 (SOIC)
TOP VIEW
AG 1
VB+ 2
C1 3
F1 4
F0 5
RS 6
SHD 7
GKD 8
TST 9
ALM 10
ILMT 11
OUT 1 12
-IN 1 13
TIP 14
28 BG
27 VB-
26 RF
25 TF
24 VFB
23 RD
22 DG
21 PR
20 PRI
19 VTX
18 C2
17 VRX
16 RFS
15 RING
TRUTH TABLE
F1 F0
ACTION
0 0 Normal Loop Feed
0 1 RD Active
1 0 Power Down Latch RESET
1 0 Power on RESET
1 1 Loop Power
Denial Active
CAUTION: These devices are sensitive to electrostatic discharge. Users should follow proper IC Handling Procedures.
Copyright © Harris Corporation 1996
1
File Number 4126









No Preview Available !

HC-5509B Даташит, Описание, Даташиты
Specifications HC-5509B3999-003
Absolute Maximum Ratings (Note 1)
Operating Conditions
Relay Drivers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5V to +15V
Maximum Supply Voltages
(VB+) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -0.5V to +7V
(VB+)-(VB-) . . . . . .
Junction Temperature
........
Ceramic.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
. . +75V
+175oC
Junction Temperature Plastic . . . . . . . . . . . . . . . . . . . . . . . . +150oC
Lead Temperature (Soldering 10s) . . . . . . . . . . . . . . . . . . . . +300oC
(For SOIC - Lead Tips Only)
Operating Temperature Range
HC-5509B3999-003. . . . . . . . . . . . . . . . . . . . . . . . . 0oC to +75oC
Storage Temperature Range . . . . . . . . . . . . . . . . . .-65oC to +150oC
Relay Drivers. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +5V to +12V
Positive Power Supply (VB+) . . . . . . . . . . . . . . . . . . . . . . . . +5V ±5%
Negative Power Supply (VB-) . . . . . . . . . . . . . . . . . . . . -42V to -58V
Loop Resistance (RL) . . . . . . . . . . . . . . . . . 200to 1750(Note 2)
Thermal Information
Thermal Resistance (Typical)
θJA (oC/W)
SOIC Package . . . . . . . . . . . . . . . . . . . . . . . . . . .
75
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation
of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
Electrical Specifications
Unless Otherwise Specified, Typical Parameters are at TA = +25oC, Min-Max Parameters are Over
Operating Temperature Range, VB- = -48V, VB+ = +5V, AG = DG = BG = 0V. All AC Parameters are
specified at 6002-Wire Terminating Impedance.
PARAMETER
TEST CONDITIONS
MIN TYP MAX UNITS
AC TRANSMISSION PARAMETERS
RX Input Impedance
300Hz to 3.4kHz (Note 3)
- 100 -
k
TX Output Impedance
300Hz to 3.4kHz (Note 3)
- - 20
4-Wire Input Overload Level
300Hz to 3.4kHz RL = 1200,
600Reference
+1.5 -
- VPEAK
2-Wire Return Loss
Matched for 600(Note 3)
SRL LO
26 35 - dB
ERL 30 40 - dB
SRL HI
30 40 - dB
2-Wire Longitudinal to Metallic Balance
Off Hook
Per ANSI/IEEE STD 455-1976 (Note 3)
300Hz to 3400Hz
58 63 - dB
4-Wire Longitudinal Balance
Off Hook
300Hz to 3400Hz (Note 3)
50 55 - dB
Low Frequency Longitudinal Balance
Longitudinal Current Capability
Insertion Loss
R.E.A. Test Circuit
ILINE = 40mA TA = +25oC (Note 3)
ILINE = 40mA TA = +25oC (Note 3)
0dBm at 1kHz, Referenced 600
- - -67 dBmp
- - 23 dBrnC
- - 30 mARMS
2-Wire/4-Wire
-
±0.05 ±0.2
dB
4-Wire/2-Wire
-
±0.05 ±0.2
dB
4-Wire/4-Wire
- - ±0.2 dB
Frequency Response
300Hz to 3400Hz (Note 3) Referenced to
Absolute Level at 1kHz, 0dBm Referenced
600Ω7
-
±0.02 ±0.05
dB
Level Linearity
Referenced to -10dBm (Note 3)
2-Wire to 4-Wire and 4-Wire to 2-Wire
+3 to -40dBm
-
-
±0.05
dB
-40 to -50dBm
- - ±0.1 dB
-50 to -55dBm
- - ±0.3 dB
2









No Preview Available !

HC-5509B Даташит, Описание, Даташиты
Specifications HC-5509B3999-003
Electrical Specifications
Unless Otherwise Specified, Typical Parameters are at TA = +25oC, Min-Max Parameters are Over
Operating Temperature Range, VB- = -48V, VB+ = +5V, AG = DG = BG = 0V. All AC Parameters are
specified at 6002-Wire Terminating Impedance. (Continued)
PARAMETER
TEST CONDITIONS
MIN TYP MAX UNITS
Absolute Delay
(Note 3)
2-Wire/4-Wire
300Hz to 3400Hz
- - 1 µs
4-Wire/2-Wire
300Hz to 3400Hz
- - 1 µs
4-Wire/4-Wire
300Hz to 3400Hz
- - 1.5 µs
Transhybrid Loss, THL
(Note 3) See Figure 1, VIN = 1VP-P at 1kHz
32
40
-
dB
Total Harmonic Distortion
2-Wire/4-Wire, 4-Wire/2-Wire, 4-Wire/4-Wire
Reference Level 0dBm at 600
300Hz to 3400Hz (Note 3)
- - -52 dB
Idle Channel Noise
(Note 3)
2-Wire and 4-Wire
C-Message
- - 5 dBrnC
Psophometric
- - -85 dBmp
3kHz Flat
- - 15 dBrn
Power Supply Rejection Ratio
VB+ to 2-Wire
VB+ to 4-Wire
VB- to 2-Wire
VB- to 4-Wire
VB+ to 4-Wire
VB- to 2-Wire
VB- to 4-Wire
VB- to 4-Wire
Ring Sync Pulse Width
(Note 3)
30Hz to 200Hz, RL = 600
(Note 3)
200Hz to 16kHz, RL = 600
20 29 - dB
20 29 - dB
20 29 - dB
20 29 - dB
30 -
- dB
30 -
- dB
20 25 - dB
20 25 - dB
50 - 500 µs
DC PARAMETERS
Loop Current Programming
Limit Range
20 40 60 mA
Accuracy
10 -
-%
Loop Current During Power Denial
Fault Currents
RL = 200
- ±3 ±5 mA
TIP to Ground
- 30 - mA
RING to Ground
- 60 - mA
TIP and RING to Ground
- 90 - mA
Switch Hook Detection Threshold
9.0 12 15 mA
Ground Key Detection Threshold
Thermal ALARM Output
14.5 10 25.5 mA
Safe Operating Die Temperature Exceeded
140
-
160 oC
3










Скачать PDF:

[ HC-5509B.PDF Даташит ]

Номер в каталогеОписаниеПроизводители
HC-5509BSLIC Subscriber Line Interface CircuitIntersil Corporation
Intersil Corporation
HC-5509B3999-003SLIC Subscriber Line Interface CircuitIntersil Corporation
Intersil Corporation

Номер в каталоге Описание Производители
TL431

100 мА, регулируемый прецизионный шунтирующий регулятор

Unisonic Technologies
Unisonic Technologies
IRF840

8 А, 500 В, N-канальный МОП-транзистор

Vishay
Vishay
LM317

Линейный стабилизатор напряжения, 1,5 А

STMicroelectronics
STMicroelectronics

DataSheet26.com    |    2020    |

  Контакты    |    Поиск