|
|
Número de pieza | NL8060BC26-30C | |
Descripción | TFT COLOR LCD MODULE | |
Fabricantes | NEC | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de NL8060BC26-30C (archivo pdf) en la parte inferior de esta página. Total 33 Páginas | ||
No Preview Available ! TFT COLOR LCD MODULE
NL8060BC26-30C
26cm (10.4 Type)
SVGA
LVDS Interface (1port)
DATA SHEET
DOD-PP-0680 (2nd edition)
This DATA SHEET is updated document from
DOD-PP-0642 (1).
All information is subject to change without notice.
Please confirm the sales representative before
starting to design your system.
Document Number: DOD-PP-0680 (2nd edition)
Published date: December 2008 CP(N)
1 © NEC LCD Technologies, Ltd.
2008 All rights reserved.
1 page NL8060BC26-30C
2. GENERAL SPECIFICATIONS
Display area
Diagonal size of display
Drive system
Display color
Pixel
Pixel arrangement
Dot pitch
Pixel pitch
Module size
Weight
Contrast ratio
Viewing angle
Designed viewing direction
Polarizer surface
Polarizer pencil-hardness
Color gamut
Response time
Luminance
Signal system
Power supply voltage
211.2 (H) × 158.4 (V) mm
26cm (10.4 inches)
a-Si TFT active matrix
16,777,216 colors (At 8-bit input, FRC terminal= High)
262,144 colors (At 6-bit input, FRC terminal= Low or Open)
800 (H) × 600 (V)pixels
RGB (Red dot, Green dot, Blue dot) vertical stripe
0.088 (H) × 0.264 (V) mm
0.264 (H) × 0.264 (V) mm
243.0 (W) × 185.1 (H) × 10.5 (D) mm (typ.)
485g (typ.)
900: 1 (typ.)
At the contrast ratio ≥ 10:1
• Horizontal: Right side 80° (typ.), Left side 80° (typ.)
• Vertical: Up side 80° (typ.), Down side 80° (typ.)
At DPS terminal= Low or Open: Normal scan
• Viewing direction without image reversal: up side (12 o'clock)
• Viewing direction with contrast peak: down side (6 o'clock)
• Viewing angle with optimum grayscale (γ≒ 2.2): normal axis
(perpendicular)
Clear + Antireflection (AR)
2H (min.) [by JIS K5400]
At LCD panel center
40% (typ.) [against NTSC color space]
Ton+Toff (10%←→ 90%)
18ms (typ.)
At IBL=5.0mArms / lamp
550cd/m2 (typ.)
LVDS 1port
(Receiver: Equivalent of THC63LVDF84B, THine Electronics Inc.)
[8-bit digital signals for data of RGB colors, Dot clock (CLK),
Data enable (DE)]
LCD panel signal processing board: 3.3V
Edge light type: 2 cold cathode fluorescent lamps (without inverter)
Backlight
Replaceable part
• Lamp holder set: Type No. 104LHS49
Power consumption
Recommended inverter (Option)
• Inverter: Type No. 104PW201
At IBL= 5.0mArms / lamp, Checkered flag pattern
6.5W (typ., Power dissipation of the inverter is not included.)
DATA SHEET DOD-PP-0680 (2nd edition)
5
5 Page 4.4 POWER SUPPLY VOLTAGE SEQUENCE
4.4.1 LCD panel signal processing board
VCC
Note1
0V
ON
3.0V
10μs ≤ Tr < 50ms
Display signals*,
Function signals 0V
Note2
0ms <t< 35ms
VALID period
NL8060BC26-30C
OFF ON
0.3V
Toff ≥ 50ms
0ms <t< 35ms
* These signals should be measured at the terminal of 100Ω resistance.
Note1: In terms of voltage variation (voltage drop) while VCC rising edge is below 3.0V, a
protection circuit may work, and then this product may not work.
Note2: Display signals (D0+/-, D1+/-, D2+/-, D3+/-, CLK+/-) and function signals (DPS, FRC,
MSL) must be Low or High impedance, exclude the VALID period (See above sequence
diagram), in order to avoid that internal circuit is damaged.
If some of display and function signals of this product are cut while this product is working,
even if the signal input to it once again, it might not work normally. VCC should be cut
when the display and function signals are stopped.
4.4.2 Inverter (Option)
Display signals,
Function signals
Note1
Note2
VALID period
VDDB
Note1: These are the display and function signals for LCD panel signal processing board.
Note2: The backlight should be turned on within the valid period of display and function signals,
in order to avoid unstable data display.
DATA SHEET DOD-PP-0680 (2nd edition)
11
11 Page |
Páginas | Total 33 Páginas | |
PDF Descargar | [ Datasheet NL8060BC26-30C.PDF ] |
Número de pieza | Descripción | Fabricantes |
NL8060BC26-30C | TFT COLOR LCD MODULE | NEC |
NL8060BC26-30D | Display Module | NEC |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |