|
|
PDF M170EG01V2 Data sheet ( Hoja de datos )
| Número de pieza | M170EG01V2 | |
| Descripción | SXGA Color TFT-LCD Module | |
| Fabricantes | AUO | |
| Logotipo |  |
|
Hay una vista previa y un enlace de descarga de M170EG01V2 (archivo pdf) en la parte inferior de esta página. Total 25 Páginas | ||
|
No Preview Available !
Product Specification
M170EG01 V.2
AU OPTRONICS CORPORATION
Product Specification
17.0” SXGA Color TFT-LCD Module
Model Name: M170EG01 V.2
Approved by
CC Chiu
Prepared by
Regina Tsou
DDBU Marketing Division / AU Optronics corporation
Customer
Checked & Approved by
ver 0.2
1/25
1 page  
Product Specification
M170EG01 V.2
1.0 Handling Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth when
handling.
7) Do not open nor modify the Module Assembly.
8) Do not press or pat the panel surface by fingers,hand or tooling.
9) Do not press the reflector sheet at the back of the module to any directions.
10) In case if a module has to be put back into the packing container slot after once it was taken out from the
container, do not press the center of the CCFL reflector edge. Instead, press at the far ends of the CCFL
reflector edge softly. Otherwise the TFT module may be damaged.
11) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the Interface
Connector of the TFT module.
12) After installation of the TFT module into an enclosure (Desktop monitor Bezel, for example), do not twist
nor bend the TFT Module even momentary. At designing the enclosure, it should be taken into
consideration that no bending/twisting forces are applied to the TFT module from outside. Otherwise the
TFT module may be damaged.
ver 0.2
5/25
5 Page 
Product Specification
4.0 Absolute Maximum Ratings
Absolute maximum ratings of the module is as following:
4.1 TFT LCD Module
Item
Logic/LCD Drive Voltage
Symbol
VIN
Min
-0.3
Max
+6
M170EG01 V.2
Unit
[Volt]
Conditions
Note 1,2
4.2 Backlight Unit
Item
CCFL Current
Symbol
ICFL
Min
-
Max
8.5
Unit
[mA] rms
Conditions
Note 1,2
4.3 Absolute Ratings of Environment
Item
Operating Temperature
Operating Humidity
Storage Temperature
Storage Humidity
Symbol
TOP
HOP
TST
HST
Min
0
8
-20
8
Max
+50
95
+60
95
Unit
[oC]
[%RH]
[oC]
[%RH]
Note 1: With in Ta (25 )
Note 2: Permanent damage to the device may occur if exceed maximum values
Note 3: For quality perfermance, please refer to AUO IIS(Incoming Inspection Standard).
Relative Humidity %
100
95
Twb=39
T=40 ,H=95%
Conditions
Note 3
Note 3
Note 3
Note 3
80
60
Storage
40 range
Operation range
T=50 ,H=55%
T=60 ,H=39%
T=65 ,H=29%
20
5
0 -20
0
Temperature
Storage
range
50 60
ver 0.2
11/25
11 Page | ||
| Páginas | Total 25 Páginas | |
| PDF Descargar | [ Datasheet M170EG01V2.PDF ] | |
Hoja de datos destacado
| Número de pieza | Descripción | Fabricantes |
| M170EG01V1 | LCD MODULE | AUO |
| M170EG01V2 | SXGA Color TFT-LCD Module | AUO |
| M170EG01V3 | LCD MODULE | AUO |
| M170EG01V5 | LCD MODULE | AUO |
| Número de pieza | Descripción | Fabricantes |
| SLA6805M | High Voltage 3 phase Motor Driver IC. |
 Sanken |
| SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
 Analog Devices |
|
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
| DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |