DataSheet26.com

GP2W0001YP PDF даташит

Спецификация GP2W0001YP изготовлена ​​​​«Sharp Electrionic Components» и имеет функцию, называемую «IrDA Data Sheet 115 kbps Transceiver».

Детали детали

Номер произв GP2W0001YP
Описание IrDA Data Sheet 115 kbps Transceiver
Производители Sharp Electrionic Components
логотип Sharp Electrionic Components логотип 

15 Pages
scroll

No Preview Available !

GP2W0001YP Даташит, Описание, Даташиты
IrDA Data Sheet
GP2W0001YP
115 kbps Transceiver
FEATURES
• Built-in Photodiode
• Operating voltage 2.7 V to 5.5 V
• In circuit design, allow for the degradation of light
emitting diode output that results from long continu-
ous operation (50% degradation/5 years).
• This product shall not contain the following materi-
als, and these materials shall not be used in the pro-
duction process for this product.
– CFCs
– Halon
– Carbon Tetrachloride
– 1.1.1. Trichloroethane (Methylchloroform)
– Specific brominated flame retardants such as the
PBBOs and PBBs are not used in this device.
INTRODUCTION
This specification applies to the outline and charac-
teristics of IrDA 1.2 type (data rate 2.4 kbps to
115.2 kbps, low power option compliant) optical data
communication transceiver.
NOTES
• Caution should be taken to prevent the detector sur-
face from being smeared with dust or dirt, or from
being touched, as it may cause faulty operation.
• Cleaning conditions:
– Solvent cleaning: Solvent temperature 45°C or
less. Immersion for 3 minutes or less.
– Ultrasonic cleaning: The effect of ultrasonic
cleaning on the device differs by cleaning bath
size, ultrasonic power output, cleaning time, PCB
size or device mounting condition, etc. Test the
device under actual conditions and confirm that
ultrasonic cleaning does not cause any immedi-
ate or potential defects.
– Cleaning solvent: The cleaning shall be carried
out with ethyl alcohol, methyl alcohol, or isopropyl
alcohol.
• In order to prevent electrostatic damage to the inte-
grated circuit, handle this device in a static-free envi-
ronment and workstation.
• External force applied to the device after mounting can
cause mounting defects such as the terminal coming
off. Be careful when handling the device and prevent
objects from touching the device after mounting.
• Refer to the ‘Precautions for Soldering’ section.
• When the system (program) is designed, the turn
around time from transmit to receive should be
designed by considering 0.5 ms or more that is spec-
ified by IrDA. This turn around time means the time
that this device temporarily does not detect the
incoming signal, since the transmitted light from the
transmitter side reaches the detector side of the
same transceiver.
• Consider that 20 ms or more (at TA = 25°C, no input
signal) is necessary to return from shut-down mode
to ready operation mode. In addition, thoroughly
confirm the operation in the actual application.
• When there is considerable external stray light or a
light source is located near the transceiver, or the
detector face receives considerable external stray
light, a pulse other than the desired signal output may
be generated as noise on the output terminal of the
transceiver. Consider the layout and structure in your
design to minimize disturbing light on the detector face.
• When the sensor is adopted in an IR communication
system, it should be used according to the signal
method specified by ‘Serial Infrared Physical Layer
Link Specification’ published by the Infrared Data
Association. Faulty operation may occur if a signal
method other than that specified is used.
1 23 456
LEDA TXD SD RXD GND VCC
R2
RL
CX2
CX1
R1
TX SD RXD
VCC
COMPONENTS RECOMMENDED VALUES
CX1 47 µF/6.3 V (NOTE)
CX2 1500 pF/25 V
R1 47 ±5%, 1/10 W (NOTE)
R2
RL
(STANDARD)
RL
(LOW POWER)
1 k±5%, 1/10 W
2.2 ±5%, 1/2 W
(VCC = 3.0 V, IE = 40 mW/sr)
33 ±1%, 1/8 W
(VCC = 3.0 V, IE = 3.6 mW/Sr)
NOTE: Choose the most suitable CX1 and R1 according to
the noise level and noise frequency of power supply.
GP2W0001YP-1
Figure 1. Recommended External Circuit
IrDA Data Sheet
1









No Preview Available !

GP2W0001YP Даташит, Описание, Даташиты
GP2W0001YP
115 kbps Transceiver
UART
1
ENCODER
CIRCUIT
DECODER
5 CIRCUIT
2
4
R1 + CX1
RL
CX2
LEDA
VCC
R2 TXD
3
GP2W0001YP
RXD
SD
GND
3
SD INPUT PERFORMANCE
HIGH
LOW or
OPEN
Normal Mode
Shutdown
Mode
NOTES:
1 Transmitting data waveform
2 Encoder circuit output waveform
3 Transmitter output optical signal waveform
4 GP2W0001YP receiver output waveform
5 Receiving data waveform
Figure 2. System Example
GP2W0001YP-2
2 IrDA Data Sheet









No Preview Available !

GP2W0001YP Даташит, Описание, Даташиты
115 kbps Transceiver
GP2W0001YP
TT
1 0 10 1
3T/16
2
3
4
LENS (PD/LED) SIDE
6 5 432 1
0.9 0.7
P 1.4 x 5 = 7
View from parts side
5 0 10 1
NOTES:
1 Transmitting data waveform
2 Encoder circuit output waveform
3 Transmitter output optical signal waveform
4 GP2W0001YP receiver output waveform
5 Receiving data waveform
T= 1
Data Rate
Data rate: 2.4 kbps, 9.6 kbps, 19.2 kbps, 38.4 kbps,
57.6 kbps, 115.2 kbps
GP2W0001YP-3
Figure 3. Signal Waveform Example
Recommended Size of
Solder Cream Paste
Open the solder mask as shown in Figure 4. The size
of solder cream paste for this device before reflow sol-
dering must be as large as the foot pattern landings.
6 5 432 1
0.9 0.7
P 1.4 x 5 = 7
Solder Mask Opening
PIN PIN NAME SYMBOL
1 LED Anode
2 Transmitter Data Input
3 Shutdown
4 Receiver Data Output
5 Ground
6 Supply Voltage
LEDA
TXD
SD
RXD
GND
VCC
NOTES: Dimensions are in mm.
Soldering paste area
GP2W0001YP-4
Figure 4. Foot Pattern and
Solder Cream Paste Size
IrDA Data Sheet
3










Скачать PDF:

[ GP2W0001YP.PDF Даташит ]

Номер в каталогеОписаниеПроизводители
GP2W0001YPIrDA Data Sheet 115 kbps TransceiverSharp Electrionic Components
Sharp Electrionic Components
GP2W0001YPLow Power Infrared TransceiverSharp Electrionic Components
Sharp Electrionic Components

Номер в каталоге Описание Производители
TL431

100 мА, регулируемый прецизионный шунтирующий регулятор

Unisonic Technologies
Unisonic Technologies
IRF840

8 А, 500 В, N-канальный МОП-транзистор

Vishay
Vishay
LM317

Линейный стабилизатор напряжения, 1,5 А

STMicroelectronics
STMicroelectronics

DataSheet26.com    |    2020    |

  Контакты    |    Поиск