|
|
Número de pieza | 6N138 | |
Descripción | High Speed Optocouplers | |
Fabricantes | LITE-ON | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de 6N138 (archivo pdf) en la parte inferior de esta página. Total 15 Páginas | ||
No Preview Available ! LITE-ON TECHNOLOGY CORPORATION
Property of Lite-on Only
6N138, 6N139
Single Channel, High Speed Optocouplers
Description
Dec.2008
These high gain series couplers use a light
emitter diode and an integrated high gain
photo detector to provide extremely high
current transfer ratio between input and
output. Separate pins for the photodiode and
output stage result in TTL compatible
saturation voltage and high speed operation.
Where desired the Vcc and Vo terminals
may be tied together to achieve conventional
photo darlington operation. A base access
terminal allows a gain bandwidth adjustment
to be made.
Functional Diagram
NC
ANODE
Cathode
VCC
VB
VO
Features
• High current transfer ratio – 2000%
typical.
• Low input current requirements – 0.5mA
• High output current – 60mA
• CTR guarantee – 0~70℃.
• Instantaneous common mode rejection
10KV/μsec
• TTL compatible output – 0.1V VOL typical
• UL, CSA approved.
NC GND
6N138 / 6N139
Truth Table (Positive Logic)
LED OUT
ON L
OFF
H
A 0.1µF bypass Capacitor must
be connected between Pin8 and
Pin5
APPLICATIONS
• Digital logic ground isolation
• Low input current line receiver
• Telephone ring detector
• EIA-RS-232C line receiver
• Current loop receiver
• High common mode noise line
receiver
Part No. : 6N138 / 6N139 series
BNS-OD-C131/A4
Page : 1 of 15
1 page LITE-ON TECHNOLOGY CORPORATION
Property of Lite-on Only
OUTLINE DIMENSIONS
8-pin DIP Surface Mount Package (6N138S / 6N139S)
*1. Year date code.
*2. 2-digit work week.
*3. Factory identification mark
(Z : Taiwan, Y : Thailand).
Dimensions are in Millimeters and (Inches).
Part No. : 6N138 / 6N139 series
Page : 5 of 15
5 Page LITE-ON TECHNOLOGY CORPORATION
Property of Lite-on Only
Isolation Characteristics
Parameter
Test Condition
Symbol Min Typ Max Units
Input-Output Insulation
Leakage Current
Withstand Insulation
Test Voltage
45% RH, t = 5s,
VI-O = 3kV DC, TA = 25oC
RH ≤ 50%, t = 1min,
TA = 25oC
II-O
VISO
5000
1.0
Input-Output Resistance VI-O = 500V DC
RI-O
1012
*All Typical at TA =25°C
Notes,
1. AC For 1 Minute, R.H. = 40 ~ 60%. Isolation voltage shall be measured using the following method.
(1) Short between anode and cathode on the primary side and between collector and emitter on the secondary
side.
(2) The isolation voltage tester with zero-cross circuit shall be used.
µA
VRMS
Ω
(3) The waveform of applied voltage shall be a sine wave.
2. For 10 Seconds
3. Current Transfer Ratio (CTR) is defined as the ration of output collector current, Io, to the forward LED
input current, IF, times 100%.
4. Pin 7 open.
5. Instantaneous common mode rejection voltage "output (1)" represents a common mode voltage variation that can
hold the output above (1) level (Vo>2.0V).Instantaneous common mode rejection voltage "output (0)" represents a
common mode voltage variation that can hold the output above (0) level (Vo<0.8V).
6. Device considered a two terminal device. Pins 1, 2, 3 and 4 shorted together and Pins 5, 6, 7 and 8 shorted together.
Part No. : 6N138 / 6N139 series
BNS-OD-C131/A4
Page : 11 of 15
11 Page |
Páginas | Total 15 Páginas | |
PDF Descargar | [ Datasheet 6N138.PDF ] |
Número de pieza | Descripción | Fabricantes |
6N134 | Hermetically Sealed / High Speed / High CMR / Logic Gate Optocouplers | Hewlett-Packard |
6N135 | High Speed Optocouplers | LITE-ON |
6N135 | High Speed Optocoupler | Vishay |
6N135 | IRED & PHOTO IC (DIGITAL LOGIC ISOLATION) | Toshiba Semiconductor |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |