|
|
Número de pieza | HK19F-DC5V | |
Descripción | Relay | |
Fabricantes | HUI KE | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de HK19F-DC5V (archivo pdf) en la parte inferior de esta página. Total 7 Páginas | ||
No Preview Available ! H U IK E
1. 安全认证:
Safety Standard:
C-UL CQC TUV
HK19F
Page: 1
2. 接点规格:
Contact Specification:
2.1 接点间隙:
Contact Gap:
2.2 接点阻抗:
Contact Resistance
2.3 接点容量:
Contact Capacity:
最小 0.15mm。
0.15mm Minimum.
初始值最大 100mΩ;
流通电流 1A、开路测试电压: 6VDC;
使用电压下降法量测。
Maximum 100mΩ at initial value.
Test Current: 1A, Open Circuit Test Voltage: 6VDC.
By using Voltage Drop Method.
125VAC Cosφ=1,可通过电流为 1 安培。
24VDC,可通过电流为 1 安培。
1 Amps at 125VAC Cosφ=1.
1Amps at 24VDC .
3. 摄氏 20 度之线圈规格:
Coil Specification at 20 °C:
3.1 额定电压:
Rated Voltage:
3.2 额定电流:( mA± 10%)
Nominal Current:
3.3 额定消耗功率:
(±
10%.)
Rated Power
Consumption:
3.4 线圈阻抗: (Ω± 10%.)
Coil Resistance:
3VDC. 5VDC.
6VDC.
9VDC.
12VDC.
24VDC
50/67/120 29.9 /40/72 25/33.3/60 16.7/22.5/40 12.5/16.7/30 6.25/8.3/15
0.15W/0.2W0.36W
60/45/25 167/125/70 240/180/100 540/400/220 960/720/400 3840/2880/1600
3.5 感动电压:
Pull In Voltage:
≦ (当电压渐渐施加于继电器时接点之动作电压,为额定电压之 80%)
V DC
≦ (Contact operating voltage when voltage is gradually applied. It is 80% of
the Rated Voltage) V DC
3.6 开放电压:
Drop Out Voltage:
≧ (当额定电压渐渐的减少时接点放开之电压,为额定电压之 10%) VDC
≧ (Contact breaking voltage when rated voltage is gradually reduced. It is
10% of the Rated Voltage) VDC
3.7 最大应加电压:
Max. Allowable
Voltage:
(为额定电压之 130%) V DC
(130% of the Rated Voltage) V DC
3.8 动作时间:
Operate Time:
在施加额定电压时最大为 6milliseconds。
6milliseconds Maximum when rated Voltage is applied.
深圳市启博电子科技有限公司
Http:// www.cnomron.com
总机:0755-28236318、28236328、28236338
深圳市宝安区新湖路华丰科技园华美居商务中心B区412B
E-mail: [email protected]
传真:0755-28236462
1 page H U IK E
HK19F
Page: 5
5.4.2 储存耐热性:
Storage Heat
Resistance
继电器在恒温箱以 70 ± 2°C 的温度连续保持 16 小时,在常温,常湿状态下,放
置 1-2 小时后,进行构造,动作,及绝缘阻抗,耐压的测试,结果需要符合 SPEC。
Relay should be kept in temperature chamber at 70 ± 2°C for 16 hours. Then
the Relays shall be maintained at standard atmospheric condition for 1 to 2
hours after which measurement shall be made. Construction, Relay
operation, Insulation Resistance and Dielectric Strength shall satisfy the
specification requirements.
5.5 耐湿性:
Moisture Resistance:
继电器以温度 40 ± 2°C 相对温度在 85%环境下连续保持 48 小时,接着,于常
温常湿放置 1-2 小时后,进行构造,动作,及绝缘阻抗,耐压的测试,结果需要
符合 SPEC。
Relay should be kept in temperature chamber at 40 ± 2°C (90~95% RH) for 48
hours. Then the Relays shall be maintained at standard atmospheric
condition for 1 to 2 hours after which measurement shall be made.
Construction, Relay operation, Insulation Resistance, Dielectric Strength shall
satisfy the specification requirements.
6. 端脚特性:
Terminal Characteristics:
6.1 端脚强度:
Terminal Strength:
在水平方向负重 300 克持续 1 分钟,测试完成后端脚不能有任何的松脱或是弯
曲。
A load of 300g should be applied to the Terminal for one minute in horizontal
direction. There should not be any looseness or bending of Terminals.
6.2 沾锡测试:
Soldering Dip Test:
温度 230 ± 5°C,时间 3 ± 0.5 秒,浸渍端子前端 3mm,须沾锡面积需达 90%以
上。
The front 3 mm of Terminal should be immersed for 3 ± 0.5 seconds at 230 ±
5°C. Soldered area must be minimum 90% of the soldering surface.
6.3 沾锡耐热性:
Soldering Heat
Resistance:
7. 重量:
Weight:
8. 抽样检查标准:
Sample Test Method:
当端脚浸到 350°C 的锡炉内 3 秒钟时,继电器必须能符合所有的电气与机械规
格之要求,且外观不会有改变。
When the Terminal are immersed into soldering bath at 350 °C for 3 seconds,
the Relay shall satisfy all electrical and mechanical specifications and must not
have excessive change in outside appearance.
约5克
Approx.5g
GB2828-2000 之抽样标准中,以一般检查水准 II 级 AQL – 0.4 为依据。
GB2828-2000 Level – General II, AQL 0.4.
深圳市启博电子科技有限公司
Http:// www.cnomron.com
总机:0755-28236318、28236328、28236338
深圳市宝安区新湖路华丰科技园华美居商务中心B区412B
E-mail: [email protected]
传真:0755-28236462
5 Page |
Páginas | Total 7 Páginas | |
PDF Descargar | [ Datasheet HK19F-DC5V.PDF ] |
Número de pieza | Descripción | Fabricantes |
HK19F-DC5V | Relay | HUI KE |
HK19F-DC5V | SUBMINIATURE DIP RELAY | EVER-WAY INDUSTRY |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |