|
|
Número de pieza | SL521 | |
Descripción | 150MHz WIDEBAND LOG AMPLIFIER | |
Fabricantes | Zarlink Semiconductor Inc | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de SL521 (archivo pdf) en la parte inferior de esta página. Total 7 Páginas | ||
No Preview Available ! This product is obsolete.
This information is available for your
convenience only.
For more information on
Zarlink’s obsolete products and
replacement product lists, please visit
http://products.zarlink.com/obsolete_products/
1 page SL521
Fig.6 Noise figure v. temperature (typical)
Fig.5 Maximum rectified output current v. temperature
(typical)
OPERATING NOTES
The amplifiers are intended for use directly coupled, as
shown in Fig 8.
The seventh stage in an untuned cascade will be giving
virtually full output on noise.
Noise may be reduced by inserting a single tuned circuit in
the chain As there is a large mismatch between stages a
simple shunt or series circuit cannot be used The choice of
network is also controlled by the need to avoid distorting the
logarithmic law; the network must give unity voltage transfer at
resonance A suitable network is shown in Fig 9. The value of
C1 must be chosen so that at resonance its admittance equals
the total loss conductance across the tuned circuit Resistor R1
may be introduced to improve the symmetry of filter response,
providing other values are adjusted for unity galn at
resonance.
A simple capacitor may not be suitable for decoupling the
output line if many stages and fast rise times are required.
Alternative arrangements may be derived, based on the
parasitic parameters given.
Values of positive supply line decoupling capacitor
requlred for untuned cascades are given below. Smaller
values can be used in high frequency tuned cascades.
Number of stages
6 or more 5 4 3
Minimum capacitance
30nF
10nF 3nF lnF
The amplifiers have been provided with two earth leads to
avoid the introduction of common ground lead inductance
between input and output circuits. The equipment designer
should take care to avoid the subsequent introduction of such
inductance.
The 500pF supply decoupling capacitor has a resistance
of, typically, 1 0Q. It is a junction type having a low breakdown
voltage and consequently the positive supply current will
increase rapidly if the supply voltage exceeds 7.5V (see
Absolute Maximum Ratings).
Fig.7 Input admittance with open-circuit output (typical)
Fig.8 Direct Coupled amplifiers
Fig.9 Suitable interstagetuned circuit
5 Page |
Páginas | Total 7 Páginas | |
PDF Descargar | [ Datasheet SL521.PDF ] |
Número de pieza | Descripción | Fabricantes |
SL520B | Chip Schottky Barrier Diodes | WEJ |
SL521 | 150MHz WIDEBAND LOG AMPLIFIER | Zarlink Semiconductor Inc |
SL521ACM | 150MHz WIDEBAND LOG AMPLIFIER | Zarlink Semiconductor Inc |
SL521BCM | 150MHz WIDEBAND LOG AMPLIFIER | Zarlink Semiconductor Inc |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |