DataSheet.es    


PDF AN2207 Data sheet ( Hoja de datos )

Número de pieza AN2207
Descripción Using the MPMC8245 Card in Standalone Mode
Fabricantes Freescale Semiconductor 
Logotipo Freescale Semiconductor Logotipo



Hay una vista previa y un enlace de descarga de AN2207 (archivo pdf) en la parte inferior de esta página.


Total 12 Páginas

No Preview Available ! AN2207 Hoja de datos, Descripción, Manual

www.DataSheet4U.com
Freescale Semiconductor, Inc.
AN2207/D
Rev. 2, 6/2003
Using the MPMC8245 Card
in Standalone Mode
Gary Milliorn
CPD Applications
This application note describes modifications that may be performed to convert the
MPMC8245 ‘Unity’ MPMC or MPMC8241 ‘UnityLC’ MPMC cards in a Sandpoint system
to a standalone operation. An MPMC card normally resides in a Sandpoint motherboard, but
for COP emulator debugging, benchmarking, or other evaluation purposes, the card can be
removed and operated without a Sandpoint motherboard by making a few simple changes to
the board. This application note covers those changes and contains the following topics:
Topic
Section 1, “Introduction”
Section 2, “Required Components”
Section 3, “Standalone Software”
Section 4, “Programming Software”
wwSectwion 5., D“Clocak”taSheet4U.com
Section 6, “Serial Header”
Section 7, “Power Connection”
Section 8, “Mechanical Standoffs”
Section 9, “Operating the Board”
Section 10, “References”
Section 11, “Revision History”
Page
2
3
3
4
5
6
7
8
8
9
9
To locate any published errata or updates for this document, refer to the web site at
http://www.freescale.com/semiconductors.
© Freescale Semiconductor, Inc., 2004. All rights reserved.
For More Information On This Product,
Go to: www.freescale.com
www.DataSheet4U.com

1 page




AN2207 pdf
www.DataSheet4U.com
Freescale Semiconductor, Inc.
Clock
4. Program the standalone bus speed:
DINK32[MPC8245] {3} >> id -i
... (skip other questions)
STANDALONE BUS SPEED: 100
(or 66, 133, etc.)
... (skip other questions)
writing I2C @100
DINK32[MPC8245] {4} >>
(wait for EEPROM write)
5. Set the SW2 options switch on the MPMC8245 board to the following settings:
DN DN UP DN DN UP DN UP
(UP = toward the ‘ON’ switch)
Now, remove the MPMC board from the Sandpoint MPMC slot and continue with the conversion process.
5 Clock
The MPMC cards normally receive their clocks from the PCI clock on the PMC header. When operating as
a standalone board, an on-board clock source is required. The MPMC8245 boards supports a location to
install a 3.3-V oscillator, which should be installed at Y1. The oscillator may be any valid PCI bus
frequency, but 33 and 66 MHz are the fastest two standard speeds.
If the MPMC will ever be reinstalled in a Sandpoint system (which will be the case if the local flash needs
to be reprogrammed using the Sandpoint-based DINK), the oscillator must be removed or the Sandpoint
system will not work, and components on either board may be damaged. Using a socket is the easiest
www.DataSheet4U.comsolution.
The socket and oscillator are installed as shown in Figure 2. Note the orientation of pin 1 and install
appropriately.
Core
Power
COP
Flash
SDRAM
SODIMM
33/66/Other MHz
3.3-V Oscillator
MPC8245
Y1
Pin 1
Pin 1
Figure 2. Oscillator Installation
Using the MPMC8245 Card in Standalone Mode
For More Information On This Product,
Go to: www.freescale.com
www.DataSheet4U.com

5 Page





AN2207 arduino
www.DataSheet4U.com
Freescale Semiconductor, Inc.
THIS PAGE INTENTIONALLY LEFT BLANK
Revision History
www.DataSheet4U.com
Using the MPMC8245 Card in Standalone Mode
For More Information On This Product,
Go to: www.freescale.com
www.DataSheet4U.com

11 Page







PáginasTotal 12 Páginas
PDF Descargar[ Datasheet AN2207.PDF ]




Hoja de datos destacado

Número de piezaDescripciónFabricantes
AN2200Acriche seriesSeoul Semiconductor
Seoul Semiconductor
AN22011A3-Beam MD System Pre-AmplifierPanasonic
Panasonic
AN2207Using the MPMC8245 Card in Standalone ModeFreescale Semiconductor
Freescale Semiconductor
AN220E04Dynamically Reconfigurable FPAAAnadigm
Anadigm

Número de piezaDescripciónFabricantes
SLA6805M

High Voltage 3 phase Motor Driver IC.

Sanken
Sanken
SDC1742

12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters.

Analog Devices
Analog Devices


DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares,
permitiéndote verlos en linea o descargarlos en PDF.


DataSheet.es    |   2020   |  Privacy Policy  |  Contacto  |  Buscar