AND8085 PDF даташит

Спецификация AND8085 изготовлена ​​​​«ON Semiconductor» и имеет функцию, называемую «An Introduction to FST».

Детали детали

Номер произв AND8085
Описание An Introduction to FST
Производители ON Semiconductor
логотип ON Semiconductor логотип 

2 Pages

No Preview Available !

AND8085 Даташит, Описание, Даташиты
An Introduction to FST
Prepared by
Fred Zlotnick
ON Semiconductor
Fast Switch Technology (FST) was introduced into the
marketplace in the early nineties and has become quite
popular with the networking and computing design
community to solve many specialized problems. Will Booth
of Insight Onsiteclaims the market was nearly $200 M in
the year 2000, and expected to continue to grow over the
next ten years. FST is the dominant bus switch technology,
prevailing over the less popular CBT (Cross Bar
Technology). FST is manufactured by ON Semiconductor
and several other important suppliers.
FST is very simply logic reduced to switches. Several
3–state devices and buffers/multiplexers are constructed
using N–Channel switches instead of logic. The result is the
same logic function, with nearly zero delay. Although, this
sounds perfect, the FST device has no drive capabilities of
its own, but merely passes a signal along, more or less
2.2 V
2.2 V
+5 V
Figure 1.
For those of you who want to understand the why and how
of this family, this diagram shows a single N–Channel FET
switch, biased at +5.0 V at the gate. A signal will pass
through the device, or not, depending upon the bias of the
gate. Interestingly, the FET can conduct in either direction
and unlike a logic gate the time it takes for a signal to pass
through this gate is close to zero. Another interesting
property is this FET, which acts just like a 5.0 V switch, until
the voltage reaches close to the supply voltage (Vcc). If the
voltage on the left were to reach 4.3 volts, the output will be
limited to within one Vφ of supply or approximately
4.3 volts. This would at first seem to be a stumbling block,
however, remember that many 5.0 volt circuits are “TTL”
compatible and any voltage > 2.2 volts is redundant. For
“CMOS” compatible circuits, the input must exceed
3.5 volts, so 4.3 V is not much of a problem. In fact, this
phenomenon, called ‘body effect’ can be used to your
advantage. If the FST has a Vcc–Vφ as its supply, by
inserting a diode in series with its supply, then, the drop will
be [1.5 V. If one side of the FET were connected to a TTL
compatible, 5.0 V device and the other were connected to a
standard CMOS device operating at 3.3 V, then the FST
device would limit the voltage seen by the CMOS device,
but the 3.3 V output would flow unimpeded to the TTL
device. This then becomes a nearly perfect logic level
translator, with almost zero delay (when turned on).
+5 V
+5 V
+3.5 V
+5 V
Figure 2.
© Semiconductor Components Industries, LLC, 2002
April, 2002 – Rev. 0
Publication Order Number:

No Preview Available !

AND8085 Даташит, Описание, Даташиты
ON Semiconductor and
are registered trademarks of Semiconductor Components Industries, LLC (SCILLC). SCILLC reserves the right to make
changes without further notice to any products herein. SCILLC makes no warranty, representation or guarantee regarding the suitability of its products for any
particular purpose, nor does SCILLC assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all
liability, including without limitation special, consequential or incidental damages. “Typical” parameters which may be provided in SCILLC data sheets and/or
specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals” must be
validated for each customer application by customer’s technical experts. SCILLC does not convey any license under its patent rights nor the rights of others.
SCILLC products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications
intended to support or sustain life, or for any other application in which the failure of the SCILLC product could create a situation where personal injury or death
may occur. Should Buyer purchase or use SCILLC products for any such unintended or unauthorized application, Buyer shall indemnify and hold SCILLC
and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees
arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that
SCILLC was negligent regarding the design or manufacture of the part. SCILLC is an Equal Opportunity/Affirmative Action Employer.
Literature Fulfillment:
Literature Distribution Center for ON Semiconductor
P.O. Box 5163, Denver, Colorado 80217 USA
Phone: 303–675–2175 or 800–344–3860 Toll Free USA/Canada
Fax: 303–675–2176 or 800–344–3867 Toll Free USA/Canada
N. American Technical Support: 800–282–9855 Toll Free USA/Canada
JAPAN: ON Semiconductor, Japan Customer Focus Center
4–32–1 Nishi–Gotanda, Shinagawa–ku, Tokyo, Japan 141–0031
Phone: 81–3–5740–2700
ON Semiconductor Website:
For additional information, please contact your local
Sales Representative.

Скачать PDF:

[ AND8085.PDF Даташит ]

Номер в каталогеОписаниеПроизводители
AND8085An Introduction to FSTON Semiconductor
ON Semiconductor
AND8085DAn Introduction to FSTON Semiconductor
ON Semiconductor

Номер в каталоге Описание Производители

100 мА, регулируемый прецизионный шунтирующий регулятор

Unisonic Technologies
Unisonic Technologies

8 А, 500 В, N-канальный МОП-транзистор


Линейный стабилизатор напряжения, 1,5 А

STMicroelectronics    |    2020    |

  Контакты    |    Поиск