|
|
Número de pieza | 43L0616A | |
Descripción | A43L0616A | |
Fabricantes | AMIC Technology | |
Logotipo | ||
Hay una vista previa y un enlace de descarga de 43L0616A (archivo pdf) en la parte inferior de esta página. Total 30 Páginas | ||
No Preview Available ! A43L0616Awww.DataSheet4U.com
512K X 16 Bit X 2 Banks Synchronous DRAM
Document Title
512K X 16 Bit X 2 Banks Synchronous DRAM
Revision History
Rev. No.
0.0
0.1
0.2
1.0
History
Initial issue
Add input/output capacitance specification
Add Cl2 spec for (-5, -5.5, -6)
Modify MRS Set Cycle Waveform error
Add -U for industrial operating temperature range
Final spec. release
Some AC parameter unit update
Issue Date
December 4, 2000
February 13, 2001
Remark
Preliminary
April 11, 2001
May 29, 2001
Final
(May, 2001, Version 1.0)
AMIC Technology, Inc.
1 page A4w3wLw.0Da6ta1S6heAet4U.com
Absolute Maximum Ratings*
Voltage on any pin relative to VSS (Vin, Vout ) . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -1.0V to +4.6V
Voltage on VDD supply relative to VSS (VDD, VDDQ )
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -1.0V to +4.6V
Storage Temperature (TSTG) . . . . . . . . . . -55°C to +150°C
Soldering Temperature X Time (TSLODER) . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 260°C X 10sec
Power Dissipation (PD) . . . . . . . . . . . . . . . . . . . . . . . . . 1W
Short Circuit Current (Ios) . . . . . . . . . . . . . . . . . . . . 50mA
*Comments
Permanent device damage may occur if “Absolute
Maximum Ratings” are exceeded.
Functional operation should be restricted to recommended
operating condition.
Exposure to higher than recommended voltage for
extended periods of time could affect device reliability.
Capacitance (TA=25°C, f=1MHz)
Parameter
Symbol
Condition
Min Typ Max Unit
Input Capacitance
CI1 A0 to A10, BA
2 4 pF
CI2 CLK, CKE, CS , RAS , CAS , WE , 2
UDQM, LDQM
4 pF
Data Input/Output Capacitance
CI/O DQ0 to DQ15
2 6 pF
DC Electrical Characteristics
Recommend operating conditions (Voltage referenced to VSS = 0V, TA = 0ºC to +70ºC or -40ºC to +85ºC)
Parameter
Symbol
Min
Typ
Max
Unit
Supply Voltage
VDD,VDDQ
3.0
3.3
3.6
V
Input High Voltage
VIH
2.0
3.0 VDD+0.3
V
Input Low Voltage
VIL -0.3
0
0.8
V
Output High Voltage
VOH 2.4
-
-
V
Output Low Voltage
VOL -
- 0.4 V
Input Leakage Current
IIL -5
-
5 µA
Output Leakage Current IOL -5 - 5 µA
Output Loading Condition
See Figure 1
Note: 1. VIL (min) = -1.5V AC (pulse width ≤ 5ns).
2. Any input 0V ≤ VIN ≤ VDD + 0.3V, all other pins are not under test = 0V
3. Dout is disabled, 0V ≤ Vout ≤ VDD
Note
Note 1
IOH = -2mA
IOL = 2mA
Note 2
Note 3
(May, 2001, Version 1.0)
4 AMIC Technology, Inc.
5 Page A4w3wLw.0Da6ta1S6heAet4U.com
Mode Register Filed Table to Program Modes
Register Programmed with MRS
Address BA A10/AP A9 A8 A7 A6 A5 A4 A3 A2 A1 A0
Function RFU RFU
(Note 1) (Note 2)
W.B.L
TM
CAS Latency BT Burst Length
Test Mode
CAS Latency
Burst Type
Burst Length
A8 A7
Type
A6 A5 A4 Latency A3 Type A2 A1 A0 BT=0
BT=1
0 0 Mode Register Set 0 0 0 Reserved 0 Sequential 0 0 0
1 Reserved
01
Vendor
001
-
1 Interleave 0 0 1
2 Reserved
10
11
Use
Only
010
011
2
3
010
011
4
8
4
8
Write Burst Length
1 0 0 Reserved
1 0 0 Reserved Reserved
A9 Length
1 0 1 Reserved
1 0 1 Reserved Reserved
0 Burst 1 1 0 Reserved
1 1 0 Reserved Reserved
1 Single Bit 1 1 1 Reserved
1 1 1 256(Full) Reserved
(Note 3)
Power Up Sequence
1. Apply power and start clock, Attempt to maintain CKE = “H”, DQM = “H” and the other pins are NOP condition at inputs.
2. Maintain stable power, stable clock and NOP input condition for a minimum of 200µs.
3. Issue precharge commands for all banks of the devices.
4. Issue 2 or more auto-refresh commands.
5. Issue a mode register set command to initialize the mode register.
cf.) Sequence of 4 & 5 may be changed.
The device is now ready for normal operation.
Note : 1. RFU(Reserved for Future Use) should stay “0” during MRS cycle.
2. If A9 is high during MRS cycle, “Burst Read Single Bit Write” function will be enabled.
3. The full column burst (256bit) is available only at Sequential mode of burst type.
(May, 2001, Version 1.0)
10 AMIC Technology, Inc.
11 Page |
Páginas | Total 30 Páginas | |
PDF Descargar | [ Datasheet 43L0616A.PDF ] |
Número de pieza | Descripción | Fabricantes |
43L0616A | A43L0616A | AMIC Technology |
Número de pieza | Descripción | Fabricantes |
SLA6805M | High Voltage 3 phase Motor Driver IC. |
Sanken |
SDC1742 | 12- and 14-Bit Hybrid Synchro / Resolver-to-Digital Converters. |
Analog Devices |
DataSheet.es es una pagina web que funciona como un repositorio de manuales o hoja de datos de muchos de los productos más populares, |
DataSheet.es | 2020 | Privacy Policy | Contacto | Buscar |